K&S12-0001 Universal Spring Type Brake Light Switch, black

So far so good, I was able to install this on my ezgo RXV in about 5 minutes. I did have to change the wire connectors to match where I needed to plug them in and all is good. I originally purchased a headlight/brake light kit for my cart and I did not like the brake pad switch that came with the kit. It was a large black pad that you are suppose to screw to the brake pedal so that when you step of the brake pedal the pressure activated the switch. I wanted more of a seamless integration but wanted the brake lights to work still. I ran across this switch and thought I would give it a shot. Installed in less than 5 minutes after changing the connectors, works great and this was able to be mounted under the floor, at the base of the pedal so that nothing is visible once the floor in reinstalled.

Worked fineI have since sold the cart

It fits my Yamaha Vmax 1200,I have had to modify the actuactor spring and eliminated the plug using 3M butt connectors.

It worked fine for about a month. YES I wired it with fuses, YES I checked polarity, YES I wired everything absolutely correctly with the right amperage and only at 12 volts. Then one day it short circuited and started smoking, then started GLOWING RED HOT AND WAS SHORTING MY LITHIUM BATTERY. So before it could literally BLOW UP my bikes battery, I ripped it off with all my might and severely burned my hand. DONT BUY IT. I will either be reaching out to the seller for a settlement or filing a lawsuit because had I not noticed it my battery could have blown both totaling my bike and my rear end covering me in boiling hot acid.

Changing from 5 to 4 stars. The mechanism needs to be better libricated. It’s been very sticky and functioning that well. I’ve used white lithium grease so let’s see how it works out.—————My car has the Ecm controlling the brake lights. After becoming defective, it left the brake lights permanently on. I had a choice of replacing the computer and then figure out how to have it programmed or bypassing the brake lights manually using this switch. This product has saved me huge headaches and large amounts aid money.

High quality product and at low cost and it only takes two minutes to install

I like the fact that it's a decent switch for really cheap, but you also get what you pay for. the same day I put it on the end of it that holds the little pieces together in the switch broke off but I was able to remedy it by shoving it all back in and pushing down the sides of the plastic to hold that piece just fine if not better.

Turning this Yamaha TT-R 230 into street legal bike. Needed a way to when I press my rear brake with my right foot, my back tail light comes on. I am making 4 different types of electric bike right now. and I have to make my own lighting harness, lights and everything else. So this was the easy, and simple fix for that problem. Whats a few more wires at this point!A little touchy, it works with very little pressure on brake.

Good quality. Works great. Many different uses.

durch meinen Fehler falsch bestellt ( ohne Betriebssystem ), zurückgesendet und problemlos und schnell den Kaufpreis und Transportkosten erstattet bekommen

j'attend toujours cette pieces