Apex RC Products 4076 2250kv 4 Pole Brushless 1/8 Motor #9720

This motor was a replacement for the mamba monster, and let me tell you, it is an awesome motor! Running 24/50 gearing in erevo and temps are good. It's a beast! Comes with 6.5mm bullet connectors and is plug and play with Brushless ERevo. Highly recommend!

Only ran on 4s with a 13/54 pinion/spur. Temps held up, after 10-15 minutes it would get pretty hot and would have to let cool before continuing

I used it in a conversation for Traxxas Tmaxc to Emaxx. The motor has been a perfect fit, tons of torque and speed, no never getting to warm. Been running with 4s Lipo.

If putting in an E-Revo the shaft is a little short for default configuration on the pinion. You must mount the pinion on BACKWARDS on the shaft before mounting the motor back in the E-Revo. This ultimately works perfectly fine. But be aware of the issue ahead of time to save yourself some time trying to figure it out.

The motor is nice and appears at first glance to be a drop in replacement for the stock motor in an e-revo 2 vxl. The problem is that shaft is too short. The grub screw in the pinion gear only just barely grabs the end the shaft. Even with plenty of thread locker, it works itself off the end of the after about 10 minutes of running. Maybe earlier versions or some batches don’t have this issue, but be aware that at least in my case I now have a nice motor that I can’t use in the vehicle I bought it for. If the shaft were just a a few millimeters longer it would be great, but as it is now, it’s not usable.

It didn’t work properly out the box and don’t waste your time with this motor

This is the second set of these motors, the first set are beyond expectation. Second set are going in a 38.25 in Mistic 5000 rc Boat, unfortunately the boat is still in the build stage but the prior twin pump boat is unreal. Tons of power and high rpm.

Perfect fit.plenty of power