bROK Loading Ramp 8-inch kit Aluminum with Full Width scratchproof Pads. Custom Create ramps with Your Wood Planks to Load Lawn Tractors, ATVs, dolleys, wheelbarrows

The groove on this kit could be a 1/4 inch wider then it would fit perfectly on a 2x8 size board. Otherwise over time you will have to readjust them as they chew away at the edge of the boards.

These make loading onto the bed of pick up truck a breeze. I bolted these to two 2”x10”x8’ boards which created a very sturdy and substantial ramp. Be sure to read the instructions that come with these. Others complained that the brackets are too thin for a 2” board to fit into the brackets. But if you read the instructions thoroughly you will see in the diagram that they are not to be fully inserted into the brackets. Otherwise they will not lay flat to the tailgate. I have loaded a very heavy generator on wheels as well as a large snowblower with ease and these handled the weight without any issues!

Item arrived on time. Pleased with item and pricing. I should have went with the unit that had the end plates, the plates that sit on ground so does not ruin the 2x6 used. But I did not because this unit was a little cheaper and I can make my own ground support plates for the ends. The upper ends are great, heavy duty thick molded ramp ends that will last and can be used over and over again. It did come with non slip pads, hardware, and aluminum ramp plates for upper board. Well worth the small price paid. Went immediately and purchased the wood for ramps, put it together (15 minute job) and have used the ramps several times so far, loading a motorcycle and scooter to haul across town. Why buy 100+ ramps when you can put ramps together your self for a fraction of the cost?Totally pleased with purchase and pricing.

Note that when you drip the holes for the bolts, they have a square just under the rounded head that will not fit into your just drilled holes. I drilled out about 1/8 inch with a larger bit and then tapped them in with a rubber mallet. Also, one of my nuts was too small to fit the bolt. Fortunately I had one in the junk drawer that fit. Not related to the product, but also try and buy your two pieces of lumber so that they weigh the same. I have one that is still pretty wet and is very stiff (good) and one that is pretty dry and flexes more so. this leads to one side depressing more and the potential for the dolly to tip and fall.

Like some of the other reviewers, I found the slot the bracket fits into is too small. I had to chip away a narrow groove for the bracket to fit as shown in their instructions. Otherwise the brackets are very good. The lip in the bracket on the underside that fits into the 2 x 8 I used, which I bought from Home Depot by the way, needed that small adjustment I chipped a small piece from the end of the boards and then fit just right.

Made my wife a ramp for her mobility scooter, works great

For loading into the truck bed

good

Good product great price simple to use

Works great !