[4-Pack] BBQ Thermometer and Probe Grommet for Grills, Replacement for Weber 85037 Smokey Mountain Cookers and DIY Sensor Port for Other Grills

One went on my Oaklahoma Joe smoker and will be adding one to my weber kettle. Easy installation w the proper tools takes around 20 min. Drilled out the hole w the step bit to proper size and inserted. take your time. Grommets have held up through 6 cooks so far.

Ultimately I got cold feed about drilling holes in my grill and sent these back, but they were well molded and nice and thick. If I ever get the courage up to punch holes through a nice grill I'll buy these again.

I installed four of these in my new Oklahoma Joe's Pro and they are leak-free even with 8 probes, two in each slot. Don't forget to drop them in hot water for a few minutes before installing them. I also recommend a little vegetable oil to ease the install.

Great deal and perfect port for multiple thermometer probes. I installed this on my Traeger BBQ075 from 2012. I did have to buy a hole saw drill bit, but aside from that this was a simple install.

After accidently melting the one that came with the WSM 18 I picked up this as a replacement. Fits perfectly, easy to install and easier to get the probes in than the original.

Pretty easy to install with the right tools. Worked great. Was nice to not have to worry about the probe lines getting crushed by the lid.

fits well, haven't used the smoker yet, so don't know yet if they hold up to the heat, but fit well, and install tightly.

Fit my WSM 22 perfect after my other one ripped. Feels like its the same material as the weber one.

Ich vergebe nur 4 Sterne, da man nicht getrennt für das Produkt und die Beschreibung vergeben kann. Das Produkt macht einen guten Eindruck, hier kann ich zunächst nichts anderes mitteilen.ABER!!!Vorsicht - nicht auf die Produktbeschreibung verlassen. Angegeben wird ein zu bohrendes Loch mit 38mm. Im "Beipackzettel" steht 1 1/4", was knapp 32mm entspricht. Ich habe mit 30mm gebohrt, da es die perfekte Größe für die Weber Variante ist und so war es hier auch. 30mm hat prima gepasst, denke 32mm ist auch ok, alles darüber nicht mehr.

I used to awkwardly try to get my temperature probes through the vent holes on the lid of the Weber kettle. It worked fine, except every time you needed to remove the lid was a two person job to slowly thread the wires back through. These mean you don't need to disturb the probes at all.You can easily drill a few holes with a stepper bit to install these in the bottom half of your kettle. The instructions are easy to follow.

Das Produkt ist im Prinzip nicht schlecht, und macht das , was es machen soll.....Kabel durchführen.Aber Achtung !!!35mm Bohrer benutzen, nicht wie in der Beschreibung 38mm. !!!!!