30ft PET Expandable Sleeving Wire Cable Sleeve (1/2", Red&Black)

Perfect for my sand rail build. Protects the wires and looks great

Okay so usually I'm not a review guy but I had to come here to address some of the bad reviews this wire loom received. Okay first things first, Yes it's not a split loom! You should be able to tell that from the pictures, split loom has a distinct fold over style you can easily see in the pictures and descriptions. Second, the fraying. These are obviously people that have never used loom before. It's braided. Meaning it will come unbraided anytime you cut the heat seal off the edges. Want to prevent that? Than either hit the tips with a lighter or butane torch and seal the ends, or properly cut them with a hot knife like they are meant to be used. Third the quality and melting of the product before heat shrink. So far I've tried 4 diff Amazon looms, eBay looms, stuff from Walmart, etc. If I seen it cheap enough I tried it....and for the price this stuff is exceptional. I will personally source this for my installs over anything else. Of course the loom is melting, its loom! Lol. Protect your wire ends properly with electrical tape or even a piece of aluminum foil before you slide the heat shrink on, then the foil before going at them with a heat gun or whatever else then the foil or tape will rip easily away. This way will also prevent unwanted unravelling until you get the ends heated.(Pic#3)

works well, didnt fray too much with heavy use. i tape up the ends with electrical tape to help

Sleeving worked well on my 12 gauge dual copper speaker wire. Easy to install and looks great when finished.

I used the 1/2" (Silver and Black) on my RCA cables for my car audio install (with white heat shrink to hold the ends). It's a snug fit to wiggle both RCA ends into the cable and start snaking it down the cable, but the fit is pretty good once it's all pulled through and snug, with heat shrink holding the ends.It will frey quickly if you don't melt the ends after snipping them.I used the 1" for my 0 gauge and 4 gauge power wires (Red / Black with red heat shrink for positive & Blue / Black with black heat shrink for the grounds). 1" is way too big for the 4 gauge, but I didn't want to order more just to make it fit better.I'm using the 3/8" for my (14 gauge and 16 gauge) speaker wires (Silver / Black) but I haven't worked on that part of my installation yet.This stuff is great to disguise same color wires. I have a roll of red 0 gauge wire and a lot of different colored 4 gauge wire, so I wrap it in this stuff to designate pos/neg, and you can't tell once it is all wrapped up. It also makes some of my cheaper looking RCA cords look very nice after they've been covered.

Works good easy to use well made.

Looks great,easy to install..I used black heat shrink to seal the ends....keeps them from fraying.Covered throttle cable,light wiring,fuel line,etc.

This is a really good quality product, but once it arrived I noticed that I didn't check the diameter closely. It's pretty hard to get much cable through here if the connectors are already on the ends. I'd definitely thread multiple cables through here if I was terminating them afterward, though. And I like the green.

Worked as designed for abrasion resistance

Calidad

Like it