RIVERWELDTIG Stubby Gas Lens Collet Body 17GL332 3/32" 2.4mm Collet 10N24S and Glass Cup Clear Quartz Nozzles #12 21.0mm Kit for DB SR WP 17 18 26 TIG Welding Torch 9pcs

Very impressed! The cup is freaking huge, offering an extreme area of gas coverage. You get what you see, and nothing more..... I’ll buy again for sure!

The insulating ring does not fit a # 17 torch as described in listing. Once the o rings are put in place the glass will NOT fit over them. Horrible choice if you expect to use it out of the box. IF your willing to do several modifications it might work. My advice is just buy something that fits like it should.

Mounted this kit on a CK 17 RG. Very satisfied with the setup, AFTER doing four quick things that turned this from a “WTF?!?” experience into an “Awww yissss” one.1) The white insulator / heat shield is a bit too small. Remedy option one: press the piss out of it. Remedy option two: heat gently… either with a heat gun, hair dryer, dunk in really hot water, etc. Will snap on like a charm. Not sure how easy it will be to remove… but I’ll find out some other day.2) I had the .040 kit. Short gas cup. With the insulator bowing/bulging a but from being stretched to fit the torch body, it makes it tough to get the end of the cup to seat well over the rear o-ring. Remedy: use two o-rings.3) O-ring on back cap is a little small. Not sure I would get a good seal back there on the torch body. Remedy: stick another one of the supplied o-rings on it! It seated perfectly between the rubberized torch body and the back cap lip when fully tightened onto the collet.4) As mentioned in numerous other reviews, the gas cap is wobbly unless stabilized further down towards the tip somehow. The modification described by another reviewer worked precisely as described (put collet body into drill chuck and mill another o-ring groove into it). Good thing it comes with four o-rings, because ya end up using them all! See the photos I took of the finished product.All in all, if you’re willing to put about 10-15 minutes into tweaking the parts as described above, you’ll be quite pleased with what you got for the money. Four stars for the product… would have been five if it worked this well out of the box with no mods.

Looks like a high quality gas lens.

As a fairly new TIG welder When I assembled the torch with this kit I thought maybe I’d done something wrong or missed something. I didn’t I assembled it correctly with a compatible torch. Everything seems to be about 2 mm off. from the way the collet sat in the torch to the way the glass was very loose, unacceptably loose and barely held in place by the green bands. Overall it was bad fit & finish.

It works great

Does not fit. Insulator is too small for CK26 torches

This does not fit a 17 at all and the cup was not threaded even if it did fit. I wish I had read the reviews, big waste of time

Only one oring holds the cup on and hardly at all. Wast of 10$ I don’t even no way they are trying to sell this product. Dosnt work

Ohne umbau hats nicht fuktioniert

Ok

Angaben falsch,passt nicht für den WP26 Brenner. Brennerdüse ist zu kurz, der Dichtring liegt schon ganz an der Isolatorkappe an und somit kann der Glas Cup nicht aufgesteckt werden.

届いた時点でガラスは、割れていました。使えません。残念です