Fender® Pre-wired Pickguard Strat® Shawbucker Bridge/Gen4 Noiseless Middle&Neck - H/S/S - White

After having spent money of a couple of decent Telecasters last year, I decided to go to the other extreme and buy the cheapest guitar on Amazon which turned out to be a Glarry Strat type guitar. Given its price, it is a reasonably playable instrument but very much amenable to upgrading.I had decided it was going to be an ongoing project for 2024, and the first thing I decided was to upgrade the pickups. I wanted to get something better without breaking the bank, so decided on the Tex-Mex pickups pre-installed on the scratchplate. First thing to note is that the scratchplate is design to fit a genuine Fender (or Squier) instrument, and the screw holes are not all in the same place as on a copy instrument. This wasn't an issue as it is quite easy to screw in the screws where there isn't a hole, at least on this instrument.The bigger issue in this instance was that the cutout for the neck needed to be cut down as the next on the Glarry has a larger heel than a Fender. This just required a decent sharp knife and some patience, although I suspect a Dremmel tool would make pretty short work of it.Compared to the stock pickups, these pickups have plenty of balls. I'm not normally much of a fan of a Strat bridge pickup on its own, but in this case it gives a lovely usable tone with a bit of light overdrive. The in-between positions give that classic Strat "quack".I would recommend this as a worthwhile upgrade to a lower spec instrument, and it's tripled the value of the original guitar too :D

Excellent quality great sounding pickups well put together on ready wired scratch plate. What’s not to like. Twenty minutes and a couple of wires to solder. Easy

20 years ago I was in the market for a Strat. I could only afford a Fender Mexican Strat at the time. It hung on the wall ,in the guitar shop, for what seemed ages. When it was in the sale, I bought it. I play Knoffler, Gilmour classic stuff. It has done a job but seemed to lack a little something. I have changed hum buckers in Yamaha guitars in the past, not for a better tone but one nearer the tone I was going for. I do not solder often and thus looked at the pre wired Mex special scratch plate option to reduce the amount of soldering to do during the change .-ve's. Obviously more expensive than just a set of three pickups on their own. The pre-wired set cost almost what I payed for the guitar! Not all the scratch plate screw holes match up with the previous scratch plate holes. No new shinny screws. Not an issue really but I had to drill a small hole for the additional earth wire.+ve's The tone is impressive. No new kit will turn you into a rock god but it inspires you to play more. My partner noticed the improvement in tone straight away. She said you can sound like Floyd and Straits after all! !!!! Less soldering and faff than if you bought just a set of new pickups. Easy to install. Watch the Youtube vid first just to see how to do it. Basically Fender "60's pickups. If you changed these on a top grade Fender you may not notice the improvement but on my Mexican made Strat, or I guess on a Squire or similar, you will notice the improvement.If you are old enough, my Blonde Mexican Strat was a Fiesta, now it is an XR2. I'm just going to open the windows and wind the volume up. Time for a go faster stripe I feel!

The media could not be loaded. In an earlier review (that I can’t edit) I stated that this loaded ‘guard comes with a 500k volume pot. Well the one I bought used, previously must have been altered, because I bought another one for an American special strat that I use a lot, and it had the 250k/500k dual gang volume and 2x 1meg time pots.It’s great. The wiring is tidy, soldering likewise.I’m a fan of the Shawbucker. It is microphonic and will suffer mic-style feedback easily on loud stages with higher gain settings, but if you control that with your positioning and volume pot you are rewarded with a much twangier, livelier humbucker than a JB or similar. That might not be what you’re after, but it does country and rock/metal convincingly and matches well with strat sounds.The N4 noiseless are also great. They don’t sound exactly like single coils, the neck is fat and round and like an exaggerated tele neck pup, kind of… but, the inbetween setting is actually very convincing and you can get a very stratty tone.Their noise-cancelling is very useful in bars with old-fashioned dimmer switched lighting. I have one regular gig like this and I can’t use normal single coils there — it’s why I use these N4 and have tried a few other noiseless type single coils. These are my favourite so far, and have become my go to.I also have two American Pro II strats with dual gang volumes and the later ‘double tap’ Shawbucker — which have a coil split and are quite a bit less microphonic than the Shawbucker.Solid choice for a quiet, versatile strat setup.

Fitted this to a 2010 mexican standard strat. Three solder points need to be done. The pickguard fits snuggly into my guitar body that is routed HSS. Its tight but it fits. No screw hole drilling necessary.The new pickups are noticeably heavier than the single coil originals so you will feel the difference in the weight of the guitar.The sound? Well I have a professional level transistor guitar amp. The sound of these pickups is... No hum on a clean tone. Very straty on all pickups. The humbucker loses all of the treble shrillness of the original single coil. You can still get the in between pickups quack sound. It sounds like a single coil strat just with the upper frequencies removed.It's more of a blues sound than the original single coils.If you play country picking music stick with single coils.If you want to hear for yourself the sound go on YouTube and look for Eric Clapton and Steve winwood concert. That is the sound of these pickups.Recommended.

I had no problem fitting this to a new guitar build and the pickups sound great.

Poor soldering in general, I had to re- fix the wires on the switch to get it working. Very poor from Fender .

I've bought lots of fender parts over the years and im obviously a fan. Today I bought another and finished up yet another strat. Ocean turquoise for this one. Don't buy aftermarket. Buy fender for fender stuff. You won't be disappointed. This one sounds exactly as a strat should. #10 for me now and I've built 4 out of those 10. Thanks amazon

The Fender Tex Mex Prewired Stratocaster Pickguard in a sleek 3-ply Black design is an absolute gem that brings new life to your Stratocaster. This prewired pickguard not only delivers exceptional performance but also saves you the hassle of intricate wiring work. I can confidently say that I'm absolutely in love with this pickguard!First and foremost, the Tex Mex pickups on this prewired pickguard provide a true sonic delight. They offer a vintage-inspired tone with a touch of extra bite, perfectly capturing the essence of that classic Stratocaster sound. From bluesy licks to gritty rock riffs, these pickups deliver exceptional clarity, warmth, and versatile tonal options.The convenience of the prewired setup cannot be overstated. It saves you time and effort by eliminating the need to meticulously solder and assemble components. The seamless installation process allows you to effortlessly upgrade your Stratocaster and get back to making music in no time.The build quality of the pickguard is top-notch, featuring a sturdy construction that ensures long-lasting durability. The 3-ply Black design adds a touch of elegance to your instrument, perfectly complementing its timeless aesthetic.Whether you're a seasoned player or a passionate enthusiast, the Fender Tex Mex Prewired Stratocaster Pickguard will undoubtedly ignite your creativity and inspire countless hours of playing. It's a remarkable upgrade that takes your Stratocaster to new heights, unlocking a world of sonic possibilities.In conclusion, the Fender Tex Mex Prewired Stratocaster Pickguard in a sleek 3-ply Black design is an absolute must-have for any Stratocaster enthusiast seeking exceptional tone and convenience. Its Tex Mex pickups deliver a vintage-inspired sound with added bite, while the prewired setup saves you time and effort. Upgrade your Stratocaster with this outstanding pickguard and experience the true essence of Fender's legendary sound.Pros:1. Exceptional tone with vintage-inspired warmth and added bite.2. Prewired setup saves time and effort during installation.3. Sturdy build quality ensures long-lasting durability.4. Elegant 3-ply Black design complements the Stratocaster's aesthetic.5. Unlocks a world of sonic possibilities for endless creativity.Upgrade your Stratocaster and unleash its full potential with the Fender Tex Mex Prewired Stratocaster Pickguard. Embrace the convenience, exceptional tone, and undeniable charm it brings to your playing experience. Prepare to be inspired as you explore new sonic territories and fall in love with your Stratocaster all over again.

Quello che cercavo. Suono pulito, materiali di qualità e cablaggi perfetti

I installed this pickguard on my 90ties Japanese Squier strat and it is a very nice upgrade to the stock pickups and electronics. It realy makes the guitar shine.

I used this product with my private label guitar and sound amazing!