Upgraded Version: 800 mAh 3.7v Li-ion Electric Toothbrush Replacement Battery Compatible with Philips HX9340 HX6930 HX6750 HX6530 HX6320 HX6950 HX9350 HX6920 HX6910 HX6710 with pins for Circuit Board

This battery worked well in my sonicare HX9112. It also came with 2 rubber seals and solder. It did take over 2 days to fully charge it. I would buy it again.

I have a Phillips Sonicare HX6710 And the battery was a perfect fit. Pins protruded through perfetly to make a good solder connection. Used a quick clamp at the bottom of the Phillips to gently squeeze the housing (The housing is oblong so please the quick clamp on the high points of the oval shape. Squeeze very gently! You should see a small gap around the bottom centerpiece And that will be enough to release the electronic assembly when you do the next step) and flip the toothbrush around then on a hard surface pushed firmly but not very hard on the metal piece that receives the toothbrush to push out the electronic assembly. (My toothbrush had a little square plastic piece on that metal head that came off after the electronic assembly released - keep your eyes open for it). My first try of reassembling I could not get the push button on the housing to push the button on the electronic assembly inside. Removed the electronic assembly. Found that I could release the push button on the housing. There are two "catches" on either side of the push button with a screwdriver. push on those catches towards the center of the push button and it will release). Reassembled the electronic assembly. and reinstall the push button (note the position of the push button rubber pin is a little bit off center and you need to make sure that it lines up with the push button on the electronic assembly in the housing before you secure it in place by pressing it into the housing). I'm hoping that this battery lasts more than a month as some have said. I always put the date of install on the battery. Perfect fit and works well at this point.

Battery fit perfectly, and electrical leads were identical to original battery. This make placement easier as you do have to wiggle the replacement around so it can snap into place with its leads protruding thru the proper printed circuit board pads. There are several YouTube videos documenting the procedure.

Tooth brush was listed as a compatible model but the tabs were just too short to go through the board. The battery does appear to be of quality otherwise.

not worth it. bought for older sonicare. removed orig battery and solder and re-soldered in new battery. fairly easy to take out and put in new battery. but only lasted a little more than 30 days. will not recharge now. time for a new sonicare!

Easy to remove old battery and install new one if you're have basic soldering iron skills; might want to use some soldering braid for a clean removal. The battery only fits in one way if you're concerned about installing it correctly. The hardest part was removing the tooth brush from it's casing. Hopefully this battery will last for several years as my original one did.Reminder - do not through the old battery in the garbage. Lowes has a battery recycling bin for disposing rechargeable batteries.

My toothbrush didn’t need it because my control board was messed up. But I ordered another handle from an auction site and used this battery to fix that one.

Perfect replacement with extended capacity from 600mah to 800mah