APIELE (Pcs of 2) 12mm Latching Push Button Switch High Round Head Stainless Steel 1 Normally Open with Ring Led (Blue)

Very nice units, work well. The lighting is nice and not too bright. Wiring is straight forward and clear.

Loving the 12mm button. The wiring took a little trial and error to work as intended. The button lighting isn't too bright, which I really like because some switches have insanely bright lighting that's distracting.I bought these 12mm buttons and the 16mm buttons and found the 12mm to be easier to use. While the button is small, the surface you press sits up high enough above the perimeter of the button that pressing it is easy. The 16mm button was more flush and, when pressed, was actually below the perimeter surface -- making pressing it again more difficult.

Good quality and good looking. Used on a video game rehab.

They always work right the first time and have great customer service. I bought these for my truck as a push button for my garage door opener. I would buy again.

no problems

Tried to use this lighted push button switch to trigger the starter motor on my boat engine. It did not work. This is a very light duty switch and may be suitable for low current installations. After it did not work, I measured the current draw with an ammeter and found that my starter was drawing 19 amps, and this switch is rated at 3 amp. But it looked cool so I had wanted to try it and did not know the amp draw. The tabs that you solder to are quite small and only will take about a 20 gauge wire. So the small gauge wire and switch caused so much voltage drop on a 19 amp load that the starter would not start. (Did also buy a Weideer Toggle Switch 12V 30A SPST Waterproof Switch from Amazon and it works great but would have preferred a momentary action push button switch). Lesson learned - know your current draw before buying.As for the LED, at 12.8 VDC, it is very dim and barely visible in an outdoor installation.

Used for lights on bass boat worked nice. The compact size made it great were i wanted to put them and led made it easy to see at night.

These latching push switches match well for the small amperage led lighting and fans in my teardrop camper build

I like the look of these switches. I’m using them to control the lift and lowering of a tonearm via an Arduino.