FingerLakes 3.5mm Microphone Assembly Mic for Car Vehicle Head Unit Bluetooth Enabled Stereo Radio GPS DVD

Clear calls. People tell me they hear NO road noise.

My custom head unit had a built-in microphone that was abysmal. This was the perfect addition, plugged into the back of the headunit. And I made sure to tuck away the cable and mount it with the included double-sided tape so it's relatively hidden while in a convenient spot on the dash.

Works OK, not as clear as talking directly into your phone. Size is 3.5mm (aka 1/8th inch 'most common' standard mini-headphone jack). Make sure you have the right receiving plug when ordering. They provide plenty of cable to reach from your overhead mount, running to your radio input.

The FingerLakes 3.5mm Microphone Assembly Mic is a good microphone for aftermarket Android head units in your car. Pros: - Easy to install - Decent quality for the price - Works as expected for calls Cons: - If you have a lot of background noise, the mic probably isn't the main issue (common with non-OEM units that aren't tuned to your specific car cabin) Mileage may vary depending on your head unit and vehicle. Don't expect it to completely fix sound quality problems if your unit struggles with noise cancellation. Would I recommend? Yes, 5 stars for compatible setups.

Much better than the one that came with my stereo. Long cord, heavy wire and works great in my truck

This microphone did improve call quality in my car compared to the built in mic, especially because my stereo is mounted little far from the driver seat. I still need to speak bit louder sometimes, but overall people can hear me better now. Decent option for the price.

Didn’t work for mine but seemed well build and good quality

I purchased this mic as a replacement for my Kenwood car stereo head unit. After plugging it it I gave it a test and found it had no audio into the unit at all. After checking and double checking that it was plugged in okay and all settings were correct, the only conclusion I could make is that I was sold a bad microphone. SInce it wasn't going to be used, I was interested to see why the mic didn't work. I started by cutting the cord to do a continuity test from each of the two wires to the 3.5mm plug. After stripping the sheathing away, I was shocked to see the miniscule "wires", not even measurable by common electrical standards (e.g. 22 gauge, 30 gauge and so on). The outer "braid" was barely there and the "center conductor" was even smaller. Both "wires" failed a continuity test from the open end to the plug. And yes, I tested my faithful VOM continuity checker to ensure it works fine. But it doesn't end there. The wires are so thin, I wondered if either would have continuity across each individual wire. Just an end to end test. Again, both wires failed. There simply isn't enough metal for each wire to have end to end continuity. I've worked with electronics for over fifty years, this is the first time I have encountered anything like this. Since this mic works for others, I can only surmise that this is a one-off issue, but still the company must be working with a very small margin on their minuscule wires. By comparison, the OEM Kenwood mic has a robust copper shield and (roughly) 30 gauge copper center conductor. It's one thing to lose a few bucks on a failed product, but losing the time to reorder something else is irritating.