ABN Brake Line Bender - 180 Degree Handheld Tubing Bender for 1/4in, 5/16in, and 3/8in Brake Line Bending Tool

You won't see this being used by a professional but it works good for someone, like me, that only uses it on rare occasions.

So far I have used this tool three times to bend 3/16” brake lines to reshape them so they can be installed on a vehicle. Tool was a bit tricky to use at first, but then I figured it out. Tool feels light, strong and great quality. I would buy this tool again and recommend it to someone for basic brake line bending.

Used it to bend copper auto brake lines.

ABN Brake Line Tubing BenderI used this several times during a mini-split heat pump install -- on 1/4" copper tubing. It was simple to use and made perfect bends.

I had never used one of these but its very easy to learn to use and made the job so much better.

Take it slow and do it properly and it will work. Used it for bending brake lines to match the factory ones and did its job well!

Cheap made, does not align well, but incredibly bends tubing quite well, I'm thinking of replacing the loose rivets that don't align well with some bolts that will.For ocasional use this is a good tool.

I bought the bender to bend up some 1/4" copper tube and found it does a good job just as long as you don't want to bend more than a 90 deg. sweep. I had read that there is a lot of the same issues with similar hand benders with smaller diameter tubing, so I figured it is just the nature of the beast. I tired it on some 3/8 tube and it worked great with that bending all e way to 180 deg.