Triton Water Heater SPINSF07MW

Great water heater. Good flow and temperature

Good water heater - used it to feed a kitchen sink that the unit is situated under, and a hand-basin in an adjacent room. Chose this one as 1. it heats the water direct, 2. did not need a Pressure Relief Valve in the plumbing configuration I used, and 3. I had an existing 6mm cable feed I could use. Flow is reasonable for the sink and it does deliver 'hot' water to the hand-basin in the adjacent room. Installation was pretty straightforward, though cable entry a bit tricky given you have to use a minimum of 6mm cable and it is a tight turn through the side of the unit and associated grommet to get it through the cable clip (it would have been easier if I had made this connection before securing the unit to the base unit).

Good quality, easy to install

This is basically a triton shower unit, no more or less. The flow required for a shower is less than that usually required at a tap for washing up etc. It can heat water to a reasonable degree but the flow is very small. OK for very occasional washing up or hand washing but keep your kettle close as you will need it. Its main attraction is that it doesn't use power until you need it, ie no tank. It could prove expensive to set up if your distribution board is a long way from the unit as it needs its own supply from the board, just the same as an electric shower.

Got this for water installation in my “shed” as I wanted to have warm tap there. Especially when I do something and need to wash my hands without going to the house. For my application it’s enough, I’m not sure if It would be enough for main hot water supply ? Always follow the instruction leaflet and use authorised electricians.

you get a good quality water heater from one of the top manufacturers in the field. this was installed in my workshop / man cave as i only had a cold water supply available . it was easy to install with straightforward and easy to understand instructions provided . once installed it offers a very good flow of hot water.

We live in a thatched cottage and have a number of outbuildings, which is where I have had this item installed - our garage in fact. This unit is ideal for locations where there is only a cold water supply. Installation was relatively simple according to our plumber, who was able to install it on the wall over a sink in under an hour: I could have done it myself, but insurance and electrics with thatched properties can be difficult if a claim arises. This wall mounted unit can be used to heat water on demand.. There is an option for two outlets, although we only need one. As our house is 20 metres from our garage it allows us now to have instant hot water, which is useful as we wash our hands now before entering our house, but mainly I see it being used to fill a bucket to clean the cars, or for when we need hot water in the garden. The unit only heats water on demand and therefore there is no electricity consumption, whilst in standby mode as there is no stored water. The controls are simple and can be adjusted to need. A good heater from a recognised manufacturer. I can see no reason not to award it five stars.

Great quality and our plumber found this very simple to install in our garage to enable my husband to have hot and cold for his workshop. It works well and fast and was good value all round. We've used it for some months now and it's still working just as well with no issues and is nice and small so doesn't take up much space. Well worth it