Red Star Ink Refill kit Suitable for HP 803 802 805 818 901 682 680 678 46 Black & Color Cartridge with 240 ml Ink, Suction Holder, Filling Tools & Instructions Combo Pack 480gm

This kit is just perfect. I started thinking that I made a mistake of not buying an ink tank printer and I have to keep purchasing costly cartridges. But this kit solved that problem. Kit quality is really good. All the syringes and needles are super strong. The suction box plastic and rubber quality is also very good. There is a bit of a learning curve when it comes to filling the tricolour cartridge. But I perfected my method in 2 3 tries. The key is to fill exactly 1 ml ink for each colour (ex-l cartridge) and do not fit them in printer immediately. Let 20-30mins go after you fill them. Let them soak for a while. Else, the ink starts leaking inside of the printer which becomes messy. The ink quality is just as good as an original ink. I tested these inks on photo paper as well as on plain paper. I would never recommend to go with original ink if you have these inks because they cost less than one fourth of the original inks. It just takes a few seconds extra to dry out.

Its not compatible for hp 802..but seller set hp802 also refilling ink.. I refill the ink properly but printer error come.. and my original cartridge also spoiled further no use..

The bottle cap are 3rd class, they won't open for first time as it locked to it's lockring, need to improve Syringes are very tight to operate while filling and pumping Suction kit spillage is there. Need to improve above quality Overall experience is average and the printed quality is ok.

Product is good, but i noticed after printing this ink fade away after few days, print gets lighter after few days.. Not sure if this happens with all refill products bcoz I'm refilling first time.

value for money

I did follow all instructions. Blue color is not working. Getting purple color instead..wasted 670 rs. Poor product..

I use a HP inkjet printer 4123 that uses HP 805 ink cartridges. What works best according to me is 1. Peel the sticker half way just enough to access the hole (middle one for black) 2. Re-fill only 3ml (max) of ink at a time, for all colours & paste the sticker back as before. If your sticker is cut or not sticking back, you can use insulation / electric tape. 3. Use the suction pad to remove just little bit of ink about 0.5 ml. 4. Gently touch the print head on the catridge on tissue paper so any excess ink gets cleaned off. 5. Let the re-filled catridge rest for about 15 minutes before installing it back on the printer. 6. Print a couple of pages just to check. The printer will still show low ink ignore it and continue to print untill the ink gets over and the pages are are coming out as faded ink or partly printed. Repeat the process 1-6. Keep in mind to be as gentle as possible do not damage the catridge contacts or the print head while re-filling. A little patience and caution is all it requires and you can save good amount of money.

I tried replacing an HP toner with this ink and it was basically a nightmare. Plus the printer doesn't recognize it so it won't print. It's worthless.