Car Bumper Protector Set for BMW X3 3 (III) G01 I 2017-2021 - Rear Bumper Guards for Cars, Anti Scratch, Paint Protection for Sill Lip - Carbon Black

Easy to apply, clean the bumper... Use the supplied fluids and squeegee......and simply wet both surfaces with the solution and slide into place......and simply squeegee the water out......Great protection.....this was a replacement for my previous one that I'd damaged reversing I to a wall resulting in the previous protector scuffed and damaged by the brick....it took all the damage...removed it and the bumper was fine.......re applied with this replacement purchase and jobs a goodun again.Great protection for avoiding bumper damage

Instructions in German especially the video but turned out to be easier to fit than anticipated. Now in place, virtually invisible and works fine. Well packaged and good quality. Very happy.

first of all, you need to go on to Luxshield website for the instruction video as the QR code takes you to a video on how to remove the protector.Not sure it is perfectly aligned to the centre, but it looks ok.be very liberal with solution 2 on the adhesive side - i did mine on a hot day and the fluid dried up very quickly - being liberal with the liquid will give you a bit more time to position the protector and apply it without too many bubbles.Overall - relatively simple application, just make sure you watch the installation video

Easy to fit, high quality think PTF film, virtually invisible........very highly recommended

Just needed heat gun to help the film fold over the bumper as our weather is always to cold for the recommended 18c to fit.Once on the car you wouldn’t know it was there, great product

Bought this to protect the rear bumper of a new BMW 5 Series Touring from the paws of my Golden Retrievers as they jump in and out. The box the film came in stated BMW 5 (G31) so it was for the correct vehicle however the film was short by 3 inches each side? Probably not an issue as the dogs paws tend not to touch the extreme of the boot sides. It also did not turn over the bumper edge to cover the top inch or so on the vertical as I was expecting. It was however easy to apply following the instructions from their online video.The film is pre-cut Oraguard Stone Guard Film (available from Amazon) so when it needs to be replaced I will buy the film separately from Amazon and make my own protector to full size.

Very easy install. Looked great when it first went on. After a couple of days it now looks terrible.

Fitted this in winter, easy to fit, just used a hair dryer to help with fitting. Bumpers protected well and can barely see the film.