OONO Forward and Reverse Relay Module for Motor/Linear Actuator, Reversing Relay Module (DC 12V)

Very easy to hook up and it work well. I put this on a lawn mower to lift the deck up and down. It worked well with the switch and electric lifts I bought.

Works like a charm

It worked but came with no instructions. It took several screw-ups to figure it out but it works and I’m about to order another.

These prewired relays are great to use! They work well and are easy to tuck & hide after installation. Instructions do help install are easy to understand!

So far, it’s installed on a seadoo jetski to run the VTS system and working good!

Works great so far. Using it in a project with a digital timer to open and close chicken coop doors. Here are some values I measured, which may save someone time figuring it out themselves. Conditions: Room temperature and 12 VDC power supply. Disclaimer 1: Accurate test equipment was not on-hand, so these are all approximate values. Disclaimer 2: Your device may not be exactly the same as mine. Manufacturer may change the design at any time, I'm sure. Standby power supply current: 0 A when both FWD & REV inputs tied to +12 V or left disconnected Supply current with FWD or REV input tied to 0 V (ground): 32 mA FWD or REV input threshold voltage that turns ON the M1/M2 outputs: +5.8 V or below (@ 17.7 mA) FWD or REV input threshold voltage that turns OFF the turned-on M1/M2 outputs: +8.2 V or above (@11.7 mA) FWD or REV input current when tied to ground: 31.5 mA FWD or REV input current when tied to +12 V: Immeasurably small FWD or REV input equivalent resistance: 350 Ω +/- 50 Ω (not directly measurable with ohmmeter, but each input behaves like this resistance when unit is powered) Module clicks when turned on/off, so it seems to contain an electromechanical relay Operation if FWD & REV inputs simultaneously tied to ground: No motor output drive & no LED lit, so this is probably not a recommended operating mode The two 0 V (ground) lines are internally connected

Haven't used yet; I plan on running 2 linear actuators to make dump bed on home - made Parade Truck.

Worked perfectly nice size.

Used it for a small motor operated valve for opening and closing

この機能がほしかったので コンパクトで非常に良かったです。 アンペアの高いものも出してほしいです。

Perfecto, todo correcto, gracias.

ottimo

Works well no surprises ,