Whiteline KLL122 Bushing Kit, Black

My Focus RS driver seat was constantly clicking and moving while driving on mountain roads. Seriously infuriating. After doing substantial forum research, they suggested these Whiteline sway bar links would hold it in place.They were not wrong.I cannot recommend these enough. I am sad I have to mod a 40k car to not have clunky seats, but this is cheaper and easier than having a dealer screw you around for a week and drop it off for them to diagnose and say nothing is wrong. Don't waste your time, buy these, clamp one on each side of a seat mount and be done with it.

I did not buy these for a sway bar. Instead, I purchased these to stop my seat in my MK3 Focus RS from wiggling back and forth, which is a known issue with big people in the Focus RS. These fit perfectly onto the seat track bar under the seat and stopped the seat from moving back and forth. These are very well constructed and I am sure they work fine as sway bar end links as well. When I get a sway bar I will buy another set for that reason.

These clamps were fairly common on posts throughout the Internet. I purchased them only to discover the milling was not very precise and the color was labeled as gold but they were VERY orange. They will probably work just fine but not too attractive on a restoration/mod project where looks are important.

I used these to correct an issue with the driver's side front seat moving sideways, during cornering, in my 2017 Focus RS2. They only took 5 minutes to install and worked perfectly to stop the movement.

As others, used for my focus RS seat. Fixed it very well! Little tight under there to get it all snuggled up but with some patience it solved the wiggle seat problem!

Well, they were supposed to be black, but they were gold. No worries though, I'm not that picky. That's the only reason they got a fours stars instead of five. They are well made and should last quite a long time.

Got these to solve an issue with my Focus ST Recaro seats. During spirited driving the seat would shift laterally on hard turns causing a clunking noise. The stock clamps on the seats are weak so even tightening didn’t work. I slapped these in and my issue is solved. No more clunk.

They are almost too big to fit on most cars with recessed sway bars. Not to mention: If your sway bars are painted, they will not hold tight. If you try to make up for the looseness by tightening them down, they are so cheaply made that they will strip out just by hand tightening. They only way these will work is if you have sway bars with bare metal, and even then, they still move from side to side even when tightened to their limit which isn’t high at all.

Wished white line would have included these in the kit.