Waterproof Iron-On Seam Sealing Fabric Fusing Adhesive Repair Tape for Dry Suit Wader Rain Jacket River Pants Clothing (Grey, 5M)

The media could not be loaded.  Got a leak in my drysuit while kayak fishing. After searching online, found this tap for DIY repairing. The price is fair and the product works really well. After pathing the hole with the tape, no more leaking. The quality of the tape looks solid. It is really easy to use. All you need is an iron to let the tape adhere to the drysuit. I add a piece of paper to get more protection for the drysuit. (check the video I posted). I highly recommend it!

Confused at first... but really just iron the damn thing on with the clear plastic contacting your neoprene. I had to cut and use several overlapping strips, but hey there was plenty of it to go around. Fixed a broken 3 inch seam on the wetsuit, without having to deal with sticky neoprene glue and extra wetsuit patches. So relieved about this product. Is holding up very well after a dozen surf outings and wet rainy weather outside.

This iron-on wetsuit repair tape did not come with instructions, which had to be “googled” for some general directions for similar products. After ironing repeatedly parts of the tape still did not adhere - one edge did but the other edge did not. Finally my husband used his wetsuit repair glue over it - this is his stand-by for any leak and has always worked to seam his suit in the past. Even so, after a short time wearing his wetsuit the piece of repair tape STILL fell off! My job is sewing - I do NOT recommend.

Seems to hold well once you figure out what heat setting to use, description says low to medium heat, but the product came with no instructions, my first attempt ended up fused to the iron.

Work like a champ. Just that describe. We put it underneath the rip on a jacket not on top of it so therefore the rip was not even noticeable. I used an iron on medium heat on a flat surface. No problems.. put it in place press down hard and let it sit overnight

Tape works as intended. Used this tape to seal the seams of my hemmed snowboard pants. Remember to use only the nylon setting of your iron. Applied the bare flat iron on the tape, making sure I don't exceed 15 seconds on each area. 2M might be enough to hem both "legs" of your snowboard pants.Will check if the seams that I sealed using this product will hold up for the 2022 winter season.

It slowed down the leak on a seam in my 3 layer waders. Some has started to peel, but the spot that leaked before, just becomes damp over time now. Works ok, cheaper than most other adhesive tapes. Id probably buy it again.

The tape works as described but some of the tape glue did not adhere to the nylon on the wetsuit. I will have to redo a few repair areas.