2 Stroke 3.5HP Outboard Motor Boat Engine Water Cooling System CDI

My14' row boat

Like the motor just did not get a title

After going threw it. Putting anti-lock on most used bolts. Choke handle broke. I have to make an new one. Where the clutch goes into the cup. The cup is grinding on something underneath. Hoping when it or if it runs. It will work itself out. Over all. What I was looking for. Greased everything. Oil in. Not bad. I like it. I had to clean up exhaust pipe. Used high temp paint on it. Looks sharp.

The second motor just arrived after the first one was shipped to Nevada instead of Indiana. Motor looks fine, but the manual is written with terrible to understand Asian grammar that is very difficult to understand. The original order talks about not being shipped with oil and so far I have not seen any place to add oil and none is mentioned in the manual, which concerns me. Don't see any lower unit filler plug. They advised me to disassemble propeller snd gear housing cover to add oil and it was easily done. Thank you.

I have not had it out in the water yet, but have oiled the gears and added my fuel, just waiting for water level on my canal to get high enough to allow launching! I would have the like the motormen emergency kill switch with a lanyard to have been included as they are required by law in my state, but it was an easy enough replacement project.

The media could not be loaded.  Fishing

Got motor in April didn't use it until August and motor barely worked

The plastic cover was cracked not to good of service