Prestige Medical 80-B/VA Inflation Bulb with Air Release Valve, 1.7 Ounce

Was a perfect to replace cracked bulb

This unit worked fine and was easy to connect to our older cuff.

Used it to pressurize my turbo wastegate to set it properly and test its range of motion based on pressure.This thing handled 14 PSI no problem and the smooth bleed off valve allowed very good control for my uses so I could dial in the 3.25PSI set value.

This is a standard-styled blood pressure cuff inflation bulb, though a bit on the smaller side. The only major thing I didn't like about it was the seem around the middle of the device. Other than that, works for what it's needed for, even if it is built a bit cheap for what I paid for it.

The original bulb had a release valve that you would push to release the air once the reading was finalized. I had to get use to leaving it slightly open prior to starting the machine in order to get an accurate reading. Outside of these differences, the bulb was made of a better quality than the original and performed to my expectations.

Only worked a few times then stopped pumping up the BP cuff.

it works

very straight forward replacement