15-0250 Etching Cream, White

انصح بشرائه

Worked very well.

I have a vinyl cutter and decided I wanted to try glass etching. This stuff works fabulously!My process was to cut my design in adhesive backed vinyl, weed out the parts of the design I wanted to etch, apply clear transfer tape to the front of the design, peel off the backing paper on the vinyl, apply it to the glass I wanted to etch, carefully peel off the transfer tape, apply a thick coat of the Armour Etch Cream using a foam pouncer, wait at least 5 minutes, wash the cream off with running water and then remove the vinyl.Here are some tips to get the best results:1. Make sure the glass is very clean. I wipe it well with rubbing alcohol to ensure there are no oils that would prevent the etching cream from etching evenly.2. Rub the vinyl hard to make sure every edge is completely adhered to the glass. If it isn't, the cream can bleed under the edges.3. Apply the cream thickly and as evenly as possible. I pounce it on rather than brush it to avoid brush marks in the etch. Make sure it's so thick that you cannot see through it at all.4. The directions say to leave it on for 5 minutes but longer is fine and makes a deeper, more frosted etch.5. Work on a covered surface and wear gloves. If this cream gets on anything else, it will etch it, too. Remember, this is an acid that is strong enough to etch glass! Also, I suggest working in a well ventilated area. I do it on my front porch.You can etch all sorts of things. Some I have etched are glass tumblers, mugs and steins, glass dinner plates and platters, glass bakeware, mirrors, canisters, jars, bottles and window glass. Etching your name onto platters and bakeware ensures it gets returned to you. Etching names and monograms onto simple glass mugs or plates turns them into fabulous gifts.This is a fairly big bottle of etching cream and even applied thickly, it will etch a lot of glass.

This was the first etching cream I used, I did try another brand but only as I was given it....I went straight back to armour! Always clean your glass for best results (I noticed a slight 'dotting effect when I rushed and hadn't). i have found on normal glassware that 5 minutes is an ideal time and a tip if a little clumsy like me, use masking tape around your stencil in case your drip or the cream runs a little during curing time. And don't forget you can use the etching cream again...I just take it off my stencil with a paint brush and put back in the bottle before I wash my glasses.

It's a little pricey on Amazon, can get it cheaper at local craft stores when they offer coupons. It is a decent product, better than other brand's glass etching creams in the sense you get more for your money and it takes less time to work. Armor Etch is not reusable once it has dried so after the initial thick layer being applied and then wiped off and put back into the bottle it only takes a little bit to achieve the frosted, etched look. It works in just a couple of minutes. One drawback is that the more times it is opened and exposed to air it forms crystals and these crystals will make darker spots on your project so they cannot be left on the glass. It is possible to eliminate the crystals by placing the bottle in warm water before each use and then shaking vigorously for several minutes to mix the broken particles. Because of the shape of the bottle it is almost impossible to stir the cream. The photo is a wine glass that I etched the word Aquarius and dotted. It is difficult to get good photos of etched glass but hopefully you can see the design well enough.

Love this, I have created some wonderful projects with this on glass and mirror, such a massive bottle as well, a little goes a long way!