ROCCS Fit for Dodge Ram 1500 Fog Lights LED DRL 2013 2014 2015 2016 2017 2018 Pair Black Daytime Running Light Passing Driving Fog Lamps Clear Lens

These fog lights are very bright and easy to install. No kidding it took maybe 20 minutes to take my stock fogs out & put these in. The kit includes enough wire for each light to meet in the middle for a T solder. So you will need wire to replace m to your fuse box for the DRLs. The only issue I’ve had since installing these in July, has been a little bit of a flicker going over bumps or rough road. I’m not sure if they designed to do that or not as all bolts are tight. Either way, I am still very satisfied with this purchase. 5⭐️Update: I should’ve known as soon as I speak on how pleased I am with these fogs, one of the DRLs isn’t as bright as the other. I just noticed this today 12/1. Hopefully it is just a bad connection. The rest of the light functions as normal.Update #2: left fog light finally stopped working all together on 4/28. These lights didn’t even make it a year.

Easy install. Section in the instructions is confusing for use of the extension plug that comes with the kit. The reviews that state the polarity is wrong needed to not use the extension. The extension plug has a male and female end with about 2 inches of wire. It is wired to reverse the polarity. You install the lights with the extension and turn on the lights, if they don't turn on you remove the extension and plug the factory plug directly into the plug on the light. LEDs only work with positive and negative in a specific location unlike the halogen. There is potential for the polarity on the plugs to not be the same from the factory, this must be why the extension cable that swaps polarity is provided. Also the kit comes with all new screws and threaded plates for mounting.Hope this clears up the polarity issues. At the end of the day for my truck I didn't have to use the extension cable. (2008 ram 3500)

Look for dodge durango model 2007 especially rear light, break electric Fuse

So when I got this (which was as quick as it should’ve been) I had to “handle” the white wire. No issues... I soldered the white wire to the red wire (splice) then I took hot glue and got glued a waterproofing shield around the area (please use gloves, as I did not and yea, back to the subject).. there is a lot of wiring might need to make a use of a zip tie to keep everything together. Easy install. Suggest getting 6 speed nuts to replace the old, or if you break or they are too rusty. But all in all, this is splendid. I did not go to the fuse block simply because I want all of it when I work my fog lights. Will update when anything arrives on their new adventures

Love the way these lights look and perform