SKF6200 2RSJEM Light Series Deep Groove Ball Bearing, Deep Groove Design, ABEC 1 Precision, Double Sealed, Contact, Steel Cage, C3 Clearance, 10mm Bore, 30mm OD, 9mm Width, 531.0 pounds Static Load Capacity, 1140.00 pounds Dynamic Load Capacity

These worked great for replacing the factory bearing on my 2006 Toyota Avalon. Toyota wanted me to replace the entire assembly-- no bueno, Toyota. You can remove the reverse-threaded nut on the tensioner and just replace the bearings with 2 of these. SKF 6203 2RSJEM.

I used these bearings for a serpentine belt tensioner pulley. The bearings did the job and saved me alot of money! Thanks!

Just what I needed for my air cooled Deutz engine's blower. Tight, smooth, and well made.

Used these to replace all 4 wheel bearings on my 2012 Harley-Davidson Fat Bob. Factory bearings were not bad yet, but i didnt want to risk the chinese made H-D bearings going out AFTER i paid money to have my new tires installed. My bike does NOT have ABS. So far after about 150 miles no complaints, doing their job wonderfully. Matched with a set of Michelin Commander II tires. Made in USA is good peace of mind too. The static and dynamic rating of one bearing exceeds the axle weight of my bike (two bearings per wheel) and these were a smidge thicker than the H-D bearings as well.Will be a 5 star experience Im sure, but dont have enough miles yet to say if they are that good.

Gate opener was making strange noises and stopping when it shouldn't. Took arm apart and found bearing was bad. Luckily it had a number on it so replaced with this one and arm is moving quietly and smooth again.

This bearing works good to replace the bearings in the idler and tensioner pulleys on 99-02 ford f150 and explorer trucks and SUV's. Normally the pulley replacement will cost you at least $18 at autozone et al ... with this bearing you can pop out the old one , replace it and reuse the pulleys for 1/2 the price. I had 4 pulleys to fix so I saved a lot of money.

USA made. Quiet and smooth. This bearing has already outlasted a previous, more expensive Chinese made bearing I originally bought as a replacement for the main bearing in a wood lathe. The Chinese bearing made noise. I thought it was going out. Did autopsy on bearing and did not see any visible flaws.

Item was exactly as described

The picture is of a 6209 bearing that is stamped USA. The 6203 bearing I ordered works fine but isn't from USA. The 6209 picture is used for many bearing sizes, which is misleading the buyer for bearing origin.