QWORK Rotary Tool Round Grinder Telescopic Hanging Stand Holder with Table Clamp, Flex Shaft Hanger Stand Tool for Household Instustrial Outdoor

Not the sturdiest, but it should hold up well enough for the occasional use I will be gibing it.

I wouldn't put anything heavy on these by any means. I ordered two to hold a shop light above my bench, and it works pretty well for that. But I wouldn't hang an expensive flex shaft from it.

I bought these to hold a Fordham type flex shaft tool but these are really weak. The base is made of plastic and as you tighten you will notice the base begin to bow! The pole is threaded into the base via a embedded nut and works itself loose very easliy. If you buy this for a Dremel then it will be fine but if you are going for a Fordham type or as in my case a Vevor SR then you will be better off going another route. Like repurposing a wig head clamp which is made of heavy-duty steel, or better an IV pole on wheels or table clamp mount.

It was easy to assemble and does what it’s supposed to do. Construction is a little on the light side.

I bought this for my father-in-law to attach to his dialysis cart. I only place 2000 mL bag on it and the plastic part that attaches to the cart just kept bending until it almost breaks. So I just bought another adapter off Amazon and attached the pole to it and it works wonderfully now. Just can’t manage to get the pole to extend all the way up.

We needed something to hang our infusion bags from and an IV pole was too tall. Installed these to the patient chair side tables and tada...perfection

I purchased a set (two) of these hangers and found a couple issues that make it an inferior product. The first is the small hook they placed on the top of the rod to hang the tool from is to wide open so it does not hold the tool in place which results in tool falling off while working. I finally bent mine around a small S-Hook so the tool would stay in place. The second and more significant problem is the cheap plastic they used for a base. When you put the product on a bench the plastic will bend and release the pressure on the clamp which of course causes the stand to fall off. The up right rod is also screwed into this cheap plastic and soon gives out giving you no way to tighten it. So even if they seem cost effective they will not last. I'm currently looking for a better made product with a metal base.

The stand is great if want portability and your rotor motor is light. I like that it breaks down and I can take it to various places. If you are looking for a more permanent place to do your work and your rotary motor is heavy - look for something more fixed and heavy duty.

Merci beaucoup

it mounts and works pretty good . it is a little flexible compared to the one i already had . it still works .

Threw it out. Waste of time returning this. Too flimsy to hold any a rotary tool, and the clamp is too weak to hold in place.

This product is very light duty. Bracket will likely break and the pole is wobbly. Not impressed.

I don't trust this to hold my flex shaft, even a small one. I've had it fall right off my workbench despite the anchor being secured tightly. The plastic material of the anchor slides easily, even when tightened until the metal side is digging into the wood. Even worse, the pole bends a lot and from just sitting in the cradle for the work day at its shortest and most stable form, it has bent itself to the point that it will no longer stand straight. Overall a complete disappointment.