Creality Resin Magnetic Flexible Steel Plate Flex Bed Kit for LD-002H SLA 3D Printer,138 x 85mm

I bought this magnetic flex plate for my Halot One, which it fits perfectly on. The kit is actually a 2 pack of flex plates, same as what you would get straight from Creality. Installation was easy, Clean existing area, align and place the magnetic sticker on top of where the build plate would be otherwise, and snap the new build-plate to the magnet. Then relevel on the 3d printer after installing.The magnet adhesive has held up and appears to be very durable. I haven't had any problems with prints sticking to the build plates. The build plates are flexible so I’m able to pop them off by bending them relatively easily. Ive been putting the build plate along with my prints in my wash station with ipa to quickly clean them off after each print. There are tabs along the top of the build plates so u can use those to get leverage and easily remove the buildplate from the magnet. The top and bottom of the build plate are the same finish and material so you can use either side as your build platform.The only downside is that the edges of these are a bit sharp. I havent cut myself, but should be something to be cautious about.