Hot RacingSLTN60M5 Steel Main Gear 0.5module 60 Tooth Latrax Rally Teton

Have not installed it just because my child is using the vehicle at the moment and do not want it flying out

I just installed this today and I have some gripes with this.1.it makes the car a LOT louder and gives it this obnoxious whining noise2. It is NOT just a drop in. I had to sand down the bushing/spacer so that the gear would line up with the pin hole in the drive shaft. You could grind part of the gear but I figured the spacer would be safer.3. You had to change the angle of the motor so that the gears mess properly, which is a pain with how it is setup in the latrax rally4. I upgrade my rally so now ALL gears are now metal and it seems like the stock brushed motor doesn’t have the torque to always start it up, it seems to have acceleration issues on occasion now.The good thing is I plan on upgrading my motor/esx and I’m hoping my metal gears will keep things from stripping out.

At first it made a horrible whining sound. After putting battery and some grease it sounds normal. Maybe even quieter than plastic. It punches great. The power transfer is smooth and it’s just about the same speed. I need to hook up my bearings that will make it faster. I will update. It’s a drop in for my Traxxas Prerunner.

The media could not be loaded.  Works as expected, it is LOUD, even with lithium grease. Some heavier grease may quiet it down, havent tried it yet so idk. I didn't have the problem with the spacer being too wide like some others did so it appears that they fixed it.

took a chance and found this to be 1:1 replacement with cheap plastic gear on my 1/18 pxtoys 9303 (also works for all models starting from 9300.no additional work necessary.

I used it to haul ass fastest teaton n South Alabama be sure to beef up the rear diffrentals axles an glue your tires running a 23 pinion with this with a velion 3m out of a e revo 1/16

This meshes perfectly with the Traxxas pinion gear and only makes a little bit of extra noise vs the stock plastic gear. I use it in a Latrax Prerunner with a 10 tooth pinion. I recommend adjusting the mesh like this: Remove the little oval metal piece from the motor mount. Loosen both motor screws and roll a folded piece of paper through the spur and pinion while pushing the gears together. Then tighten the screws. I also tried a single layer of paper but it was too tight and there was a lot of noise. Also I lubricate mine with Pedro's Chainj bike lube

Its made to last

Fits the Latrax teton , shipping was a little slow

My son kept going through spur gears and then we got this one. It’s super beefy and very good quality.