BrocraftFender Cam Cleat for Tracker Boat Versatrack System/Lund Sport Track System

I have a Ranger VX which has the track system but no round holes to allow the carriage bolts in. I had to grind 1 edge off the bolts to fit them then just turned 90 degrees to secure. Even better I didn't use the bulky metal back plate or the 2 turn knobs. (way to bulky) Took the 2 Phillip's bolts and exchanged them for the locking carriage bolts but had to drill out the holes in the knurled locks a little bigger to fit and didn't use the cap either...Bottom line it works amazing and only half the size so they just stay in place hardly noticeable!

Very poor. Does not hold fenders very well at all. Would not buy again

Angled track on Lund Impact fits well.Easy to install and use.Performs as advertised.

Use the product with the channels found on the side of a Tracker Bass boat, they are perfect for positioning my fenders on the side of the boat. Just slide the rope thru to the appropriate length and release the knurled holders, and the rope is held firmly in the positined place and does not budge until you reposition it.Easy to move in the tracks and set with the two knobs on the side. Saves using the limited cleats available on a boat for docking, my 16 footer only has 2 on a side, so without these would be next to impossible to tie up to the dock and position fenders at the same time.Small,easy to place out of the way. Worth their weight in gold. :-)

Kind of pricey, but we're a nifty solution to hanging the fender where there was no cleat. After less than 2 season the screw that hold the cam worked loose and came out. The screw will not go back in. It just spins.