Creality 3D Upgraded Platform 2 Pack, Resin Magnetic Flexible Steel Plate Flex Bed for LD-002H Resin 3D Printer Size 138x85x0.4mm

I believe this is a must-have. I don't have to remove the bed and try to scrape part off. I have no problems with it sticking magnetically.

No complaints, this is a great upgrade for the Halot One. A WORD OF CAUTION THOUGH: These plates are very thin and can cut through gloves/skin if you slide your fingers across them with force (think "paper cut"). This is not a flaw of the design, just the nature of a thin metal plate.

I was extremely excited buying this as an opportunity to make my printing a tiny bit easier, and it was a complete disaster. When I got them it the flex plates and magnets that came were bit big for my printer LD 002R (it uses the same platform as the LD 002H) , I looked at some videos and the suggestion was to trim the magnet to fit and adjusted the plate and made sure it wasn't hitting the side of the vats. I made sure to thoroughly clean my plate before sticking the magnet on, and I waited 48 hours after installing to print something and that is when the massive failure happened the adhesive on the magnet didn't hold and the build plate and magnet were under all that resin. so I spent my time after work cleaning my printer changing my fep and regretting the decision that I made when I purchased these.

Product was very easy to install and the adhesive for the magnetic sticks really well, just make sure build plate is completely clean and no resin residue. The plate holds almost to well to the magnet and I have not had any parts warp or corners flex although I have not tried printing one large part over the entire build surface.

I bought these to get started. Waited the 72 hours after installing before using it, and it worked flawlessly for 3 bottles of resin. However on a very heavy print, one end of the magnetic plate came off, and won't reattach (because it had resin on it).I am installing the second one now. If this one sticks then it is simply a great product. (I have 2 print plates, so if I can't reattach the magnetic plate will have to get another set).

Having dual plates like this is a life saver. Being able to pull the part off without having to take the hold print head out makes printing much faster so I can keep getting parts printed.I would recommend hitting the plate with a bit of sand paper before printing just to give an extra bit of texture to grab onto. because of how thin the metal is, I did cut my hand once on this while trying to get parts off of it, so be careful.

So I'm giving this five stars because it does make things much easier. But first you have to give the plate a good roughing up I hit it with 120 grit lightly and it was not really enough so I used some 80 grit with medium pressure and seemed to do the trick. I would recommend that the manufacturer care less about the nice look of the plate and go for function instead.

I took one star because right out of the box prints are not sticking to it, you need to take scotch pad and scrape it mildly. NO don't use 120 sand paper like some reviews say you want some smoothness and have your prints come out. your moms scotch_brite the rough side not sponge side is good enough.I took another star off because it scratched my vat. the lift tabs are too big. you have to put the build plate of centered. I don't understand how a Creality product made for Creality printer doesn't fit?

Necesita ser lijado antes de usar, pero facilita la limpieza del modelo y de la impresora, la instalé en una LD-002H