Caliber Trailer Lift Metal Ends

Bought and installed on my spartan snowmobile trailer. Works great and holding the trailer up for loading

This kit was designed for a centerline tilt trailer but it also works on larger flatbed trailers. The ball stud brackets in the kit won't work for this application so I used 10mm ball studs with a 3/4in shank and drilled holes through the frame on my BigTex 70ST and it works great. I put one Claiber lift on each side to get a slower close rate but just one keeps the bed in the raised position.

was a little hard to install seams directions could be a little easier.

Fairly easy to install, just measure correctly.Works great and holds trailer up perfectly.

Buy new screws. Quality of self tapping screws that came with it are junk. Installed properly according to instructions. Set trailer back down and screws snapped after first few lifts. Arm seems good but hardware is sub par.

I didn't want to mount one end to plywood.So I repositioned it so it would mount to metal...and be out of the way of my lift lock. Works nice!

Previous one held the trailer up but rusted out after a number of years. Replaced it with this one and it will not hold the trailer up. Waste of $.

Comes with all mounting hardware and instruction on how to line everything up and it only took me about an hour by myself to install. I used this on my triton clam shell tilt trailer. Was always a pain if you were trying to load anything on the trailer by yourself and this has enough pressure to hold the trailer in the loading position even with the snowmobile on the trailer. I would recommend to anyone with the same type of trailer