evernice Treadle Rod Ball Joint Adjustable for Juki Ddl-8500 8700 5550

wished the the rod comes longer than 24cm as it was too short for the motor.

This will work on just about any clutch motor or a servo motor you may have.I am building my own special Industrial sewing machine and it is a Singer 20U with a special K-stand and a very good clutch motor for this setup.My other sewing machine is the Singer 191D-30 with a servo motor.

Broken foot pedal bar on a consew machineOnly needed one half , now works like new

Works fine for foot peddle.

These arrived quickly, and were what I expected. The threads on some of the eye socket ends were not as well formed as I would like, but I doubt there will be any functionality issues because of it. Just don't over tighten the jam nut.I wish that the studs in the pressed ball joint were lubricated, but I took care of that by working in some moly grease. Doing this will extend the life of the rods, and keep them from wearing out over time.I will probably buy these again. I care for about 35 machines at my shop, so it is more than likely I will need more later. That being said, of those that I have replaced, and packed some moly grease in the ball joint, it is unlikely that they will need replacement for many years.In short, I recommend these.