RAINPAL RBI125F Inlet Fitting

I used this with a blue barrel, but it should work fine with any barrel that has fine threads. That's important, as most barrels have 2 bung holes, 1 will be fine thread, and the other hole will be coarse, or (in barrel-speak) a buttress thread.If you make your rain water catch system like I did, you'll use the fine threaded holes for the PVC pipe to connect 2 barrels, so you'll be left with a buttress thread for the water inlet - which is what this is for. So you'll need to find a 2 inch buttress thread to fine thread adapter to make it work. (I used this one: https://www.amazon.com/gp/product/B00MWYLOA2/ref=ppx_yo_dt_b_asin_title_o08_s00?ie=UTF8&psc=1)I've attached a few pictures that hopefully make it easier to understand how I made my system. 2 inch PVC to connect the barrels, the spigot fit into the lower buttress thread cap, and this (with an adapter) fit into the top.

Bought one for my water storage barrel and it has developed a small pin hole leak at the point where the spout starts. Very small and slow leak. I keep my water storage outside so it's not much of an issue. The temp has never gone below 40F since it was installed and the leak has just begun in the last couple months since it has been hot out.

Worked like a charm. Planning on putting another rain barrel in next spring. I will definitely buy again.

Works like a charm, although I ended up not needing it for my rain barrel setup

Perfect, just what I needed....

It screwed into my rain barrel bung perfectly. Worked great.

Awesome product.

GREAT