10mm Connectors Kit for PAUTIX COB CCT Tunable Strip Lights,4pcs Transparent Gapless Middle Connectors,3pcs Dual End UL Listed 22AWG Extension Wire

Re 2 star review:These aren't made for soldering. The structure of the connectors is pretty clear in the photos and description so I have no idea why is there the expectation for it to be reuseable.>cannot solder wires and wire too shortIf you want to connect your own wires:A. Cut the provided wire and splice your own, orB. Remove the flex PCB they attached the wires to, remove the soldered wires, solder your own wires, put the pcb back in and crimp with the strip installed.They used a pretty hard adhesive so you can just remove the pcb from the connector by pushing up from below to break the adhesive, then wiggling it out. If that didn't work, a thin prying tool will likely get it out. The mechanical attachment is mostly through the puncturing tabs, so it will still hold after you have crimped it, even after the adhesive is broken.This is much better value than the BTF ones. I have not tested crimping these on actual strips, will update when I have done so, but they look fine.

I bought two packs which is more than I needed. I ended up buying one more to finish one wall as most of the longer connections just don’t work. I had to recut and reconnect strings to keep trying. I just needed 3 corners and literally only one corner is being used out of 3 packs, the others I just bent light strings as none of these worked. Garbage.

Nice to have to make turns. But this 10mm COB 3 wire does not have anything to connect from the contoller to a cut strip. I had to cut the connectors in half.Solder on some pins to connect to another controller. Would be nice if they just sold the pigtail to solder on directly to the strip.

A useful tool to get the most out of the Pautix 10 mm 2700k-6500k light kit. Very easy to use to customize your diy project.

This review is only for the connectors. I was hoping I could use these to minimize soldering on the strips. Unfortunately each of them is in one solid piece; I can't really solder wires on one end and connect the other end to the strip, as the opening is too narrow to solder. And the ones with pre-installed wires are only about 6 inches long, way too short for my setup. Also I can't really test run these because once I clip them with a plier, they are permanent. The strips are great, but these connectors, I can't recommend.

Works as described, so happy they finally sell these!

Please don't bother. It has too many ohms of resistance and the power supply being so low in voltage causes the color of the segment to be noticeably lower in warmth of light and dim. Hard pass

I bought these 10mm Pautix connector to use with the Pautix COB strips I installed.One (very minor) point is the transparent short connectors cast a small shadow at the connection point that might annoy those with OCD issues.They are super simple to use and very reasonably priced. I highly recommend them.