HIPA 791-182353 Fuel Line Kit for MTD Troy-Bilt TB144 TB26CO TB26TB TB415CS TB465SS TB475SS TB490BC Yard Man YM141 YM21SS YM26BC YM26CO YM26CS YM260CS Trimmer with Primer Bulb Tune Up Kit

This was a great kit. The fuel line is stretchy enough to pull through the small fuel tank holes and there is enough line to make a mistake or two. It can easily service 2 machines, but I had enough fuel line left over to also replace an oiler line on my chain attachment and another bad fuel line on a blower. The rubber priming bulbs are just a bit smaller than some and may not fit all makes of carburetor.

Fits like original works better. No issues

Really easy to install just a few minutes and I was back to work.

Used this kit on a 20yr old Troy-Bilt garden tiller/cultivator that had been buried in the corner of the garage for most of those 20yrs. The fuel lines were broken (hard and brittle) and the fuel filter was completely deteriorated inside the tank. Installed the new fuel lines (a little bit of a challenge to push the new lines through the holes in the tank but doable) and the primer bulb, added fresh gas and it cranked right up after the second pull. Very good value for the price of the kit. Couldn't use the spark plug as it was the wrong one for my application. It wasn't needed anyway so not a problem for me.

I have a Troy Built TB425CS, and as other have mentioned... the spark plug is the wrong one and the fuel line is too big (inside diameter is sloppy on the carburetor tubes). The primer bulbs are what I wanted, and those work fine. Also, the fuel filters work fine. So, for the Troy Built TB425CS I would give it 2 1/2 stars if I could, because only half of the items are usable. I rounded up instead of down due to the price being very reasonable.The vendor should really update their description.

Just the parts required to fix old tiller

Worked great for my Craftsman backpack 2 stroke leaf blower

My fuel pickup line broke on my Troy-bilt TB415CS trimmer. Even though my model is on the approved list, the parts do not fit. As many others have mentioned, the spark plug does not fit. They furnish 2 different lines in the kit and I believe the black line is for the return and the clear line is for the fuel pickup (at least that's how I tried to install them). I could not get the black line in the hole of the gas tank where the old fuel return line was, so had to use the clear tubing, which seems to have a smaller outside diameter. I did cut a taper on the line and lubricated it with oil, but it still would not go in the gas tank hole. The clear line went in without too much trouble and I installed one of the new filters on it. When I attached it to the carburetor, the line was not very tight, but thought it would be alright. I did not replace the primer bulb, since my old one is working fine. When I pump the primer, I can see gas moving through the lines, but the trimmer will not start. I'm not sure if the fuel line is tight enough to keep air from getting in and that may be the problem. It was very hot today, so I'll try starting it again tomorrow when it's a little cooler to see if the extreme heat may have been a factor (not sure what the heat index was today, but it was 113 yesterday). If I can't get it started tomorrow, I'm going to see if I can return what's left of the kit.**Update** Could not get the engine started so I purchased "MTD Genuine Parts Trimmer/Blower Fuel Line Kit" (less than $10 on Amazon - I bought mine at a big box since I didn't want to wait) and replaced the lines that I installed the day before. The trimmer started right up so I can only assume that the loose gas line was the problem. So neither line in the HIPA kit worked on my trimmer, the spark plug was not the correct one for my trimmer (even though it's listed). I don't know about the primer bulbs since I didn't use them, but I'll keep them rather than return this since it's not worth the time to get back the $7.65 I spent for it.

It was just what I needed for my rototiller maintenance.

Replacement parts for my troy bilt trimmer

The description included my model of a Troy-Bilt, but the spark plug was the wrong size and did not fit my trimmer. Primmer bulb worked as well as filter and fuel lines.

Every thing was good except the spark plug is not the right one