20 Pcs LED Tape Light Connectors 4 Pcs L Shape 2 Pin LED Connectors for Strip Lights Right Angle Terminal Block Solderless Adapter Screw Down 8mm Tape to Wire for 5V 12V 24V LED Strip Lights

Super easy to use. Small screwdriver is all that’s needed to connect your led lights. I worked and worked to connect my lights but then purchased these and my problems were solved. Small but able to get the job done properly and safely.

Only one side will accept the strip so you cannot use it to splice two pieces together. Also the strip side is too narrow so I had to trim both sides of the strip to get it to fit. Wire side is small too so use small gauge wire. Works ok. I will look for alternatives next project.

I got these to work with 8mm COB led. These continuous led strips have a continuous bump in the middle of the entire strip so when I cut at the lines and tried to insert into the connector, the plastic center part of the connector was interfering with the cob led strip. The strip tended to push out of the connector. I was able to make it work by holding the connector and strip down tightly while jamming the strip into the connector and screwing it down. Would I use it again? Probably. The connections worked fine once I got the strip and wires in.

Only needed 2 but so far great product

Height is 8 mm NOT .87 mm as Labeled. If you’re planning to use U shaped channel be sure to check its INSIDE height dimension. V channel for 8 & 10 mm strip works.

If trying to conceal connection this item is bulky, the connection isn't as strong as it seems, led slips out even when tight

Cheap Trash 🗑 🚮

Take your time. There is definitely a learning curve but these are the best thing for strip to strip or strip to wire . Bery secure connection. Ibe had issues with other connectors. These arent going to budge . They are a bit clunky if using in the aluminum channels but they will fit with a bit of fenageling. Patience.. take your time . Will purchase again.