Mini Pix

So confusing to setup. Could not calibrate radio. Tried two different receivers including I bus and S bus, but no luck. NOT USER FRIENDLY!

if you want to use a packet like this get the cross flight it has built in OSD

Make sure the board is compatible with the flyer you are building.

This flight controller is trash. The seller was prompt at least. Save your money and get a real Pixhawk. This board does not even support the newest firmware on which Arducopter recommends. Matter of fact, its firmware is generations behind, and is no longer supported by the online community. Many options were grayed out or non existent in Mission Planner. I tried this board on two different uav's same wobblyness, that I could not tune out. I just gave up. And when I reached out to RCGroups or Mission Planner (Arducopter) forums, and I told them which FC I had. Their immediate response was to trash this thing and get a real pixhawk or go back to a Betaflight board. And thats what I did.

Good just take a bit of prior knowledge on programming flight controllers to work it