LED Panel Surface Mounting Frame Box Kit for Ceiling Panel 600 x 600 White Body

Good quality. It does the job. Easy to assemble

The corner fittings were very flimsy and not accurately made.Broke the retaining tabs on 2 of the fittings.However the supplier promptly replaced with a better fitting. with accurate fit and a screw retainer.Now looks very good and pleased with the suppliers rectification.You must install squarely. fitting one side first and then loosely fit the 2 ends and the other side and mark the side frame screw holes on checking with a Try square that they are perfectly square with the installed side frame.

Excellent concept and looks very nice once fitted, but this needs two pairs of hands, plenty of time and a clear head to fit it successfully. The task would have been so much easier if a paper template had been included, or at least if the holes in the two opposing rails needing to be fixed to the ceiling were symmetrical and identical. Fixing the first side is easy, but positioning the second rail is difficult when the 'diagonals' between the fixing holes are not the same and you can't mark the drilling points with the panel held in position.

Very quick and easy to fit. Neat and smart against the ceiling. Visitors often believe the illuminated fitting is a skylight as the result is so close to natural daylight on a sunny day. Working in this previously gloomy kitchen is a shadow-free pleasure. Two more have been ordered for the utility room, I'm looking forward to getting them fitted

I found this to be hard to install as side clips are flimsy and getting it square proved awkward as light kept pushing the sides apart. Managing to hide the mounting screws means you can't adjust them once the lights in. It looks ok but it's not really the solution I wanted.

I installed two of these. I found it best to start with one of the sides with screw holes and mount that, then put the rest of the box in place, use a square to get it all true and then mark the holdes for the opposite side, the corners can just pop back out so you can move the sides out of the way for drilling. I used this approach because otherwise you can end up with an off -square box. With only 3 sides fitted the light slides in, but as in my case if the cable is a bit awkward the sides will flex sufficiently that can simply push it in to place and just slide the last few inches. If you are in a constrained space, then having assembled the box on the ceiling, you can take off the two removable ennds, simply push the panel up into the space, then add the ends back. It is important to make sure the corner clips are pushed fully in otherwise the little peg that holds them in pace will not engage.

Great product ,i recommend.

Fantastic product, it arrives in kit form, but very easy to assemble, looks nice to.