ThetfordAqua-Magic® VI High Profile, White

The toilet works well and was about 2 inches higher than the one it replaced. Like the higher toilet but water supply line was not long enough, I had to cut the water line and extend to fit. I did this using fittings normally used for sprinkler systems. Very pleased with toilet.

Installed easily over old aqua magic iv mounting position. Looks nice and functions well. The soft close lid is extremely slow.

There was nothing wrong with the old Dometic it replaced, other than it was old, faded, not soft closing, and low profile.This toilet is taller, wider and it has a soft closing seat. Looks great in the bath, easy install and it came with the necessary seal, new bolts and caps.The bath is now a much improved space with this toilet and the new roof vent I installed at the same time.

It's a big improvement from my Thetford V. It sets a little higher and has a large bowl. Easy install. If you are overweight, this may not be for you. I am about 50 lbs. overweight. The seat is a little flimsy. I hope that it lasts longer than my last toilet. That one only lasted a couple of years. The mechanism in the back failed and the gasket was broken and worned big time.

Bought to replace a Dometic 300 series toilet that we didn't love with hopes of fixing the problem we've had with black tank smell. Rather than attempting to replace the seals AGAIN on the old toilet, thought we'd replace it with this Thetford and see if that would help. Several things about the Thetford make it better (for us) than the old Dometic. First, although this one is just the same height as the Dometic, it's a slightly smaller around and fits the space better. Also, there is only one internal seal, at the bowl, whereas the Dometic has two seals inside to fail. Finally, the flush pedal is at the front on the Thetford. The dometic pedal was on the right side, which made it awkward to flush with the limited space in our bathroom. I did have to re-do the water supply line in the RV, as this one connects at the top center, vs the bottom right of the Dometic, but that was a simple job. Once I had extended the supply line, the toilet was super simple with everything we needed (other than a wrench) in the box. No instructions were in the box but there was a QR code to scan if you needed it. Easy DIY project. So far so good, as we let it sit in the heat for 2 days now and there's no tank smell at all.

I have been Rving for about 25 years. Maybe my 4th Thetford?Replaced a V with a VI. Everything matched up perfectly. Bolts the same, holes matched up. Water valve at same height, so, no changes needed. Fittings the same, no Pex changes needed. Sits up a bit higher, a nice throne. Water jet better too, does a better job. No splashes, as others have said. Bigger bowl too. Came with bolts & bottom seal.Issues. No instructions. I did not need them, but they could have had basics, including plumbing requirements.. Also, base could be stronger. It is easy to overtighten; ask me how I know. Not a bad idea to get some washers to go with nuts, spread the torque over a larger area.Price wad goo too, shipping OK.

Easy to install. Seat is a little small. Flushes with lots of water. Overall it’s very nice.

No leaks, works as intended. Works better than the half high one it replaced. I had to unscrew the hold down righ on the floor and twist it to screw the toilet to it, but not complicated. I also had to splice in more water supply line as this is connected at the tol and the old one connected at the bottom.