Sequential Turn Signal Motorcycle Blinkers LED Front Rear Flowing Indicators Daytime Running Light Universal Compatible with Harley Honda Kawasaki Suzuki Yamaha

These look great on the bike and are very bright. A little tricky to install (my advice would be to also buy the connection wiring for your bike and wire them in to that so they just plug right in. I used the wiring from the old signals as they were broken off. Would also advise wiring the snap connector receivers into the connection wiring because butt connectors are a pain at this gauge). Just waiting on the diode wire kit now because my bike has the four way flash issue. A little smaller than you'd think but seem good quality, nothing broke or came unfastened while installing, and they are good and tight. Can't beat four signals for this price, honestly.

While I knew what I was getting into before purchasing, I made a mistake and broke one, but ordered a second pair. Delivery both times were quite prompt. The look is quite well, they flow with a 2004 Suzuki Marauder quite well. Just got to have some DIY skills and installation isnt all that bad. The whites aren't super bright in the front, but they are noticeable while the blinkers do their job as ler normal, nobody pays attention to them anyhow. I have the rears as brake lights/blinkers and they work on que every time. If you have an older bike, you may run into the no blink or fast blinking due to your blinker relay being for traditional blinkers. As well, it would behoove you to purchase yet again, if your bike or atv have tradional blinkers to start with, the voltage regulators. They help tremendously with brightness. LED's don't require heat to turn on, just low power source. Which the tradional relay cannot muster quick enough, thus giving you the fore mentioned issue. Just make sure you do your studying before purchasing LED blinkers. Over all though the blinkers and brake/running lights are great for what they are. They are sleek and add a kind of future feel to the bike while still delivering the proper functionality. Hope this helps some of you.

A little cheaply made but we're actually pretty durable they fit okay brightness is okay installation was okay.

Horrible lights you constantly hit them when you get off your bike and getting on some of the LEDs quit working inside the light so I took it apart and it was very cheaply made had water damage on the PCB, this screw is not stainless steel so it rust, I’m out right now trying to find replacements and I’m driving without blinkers hoping I don’t get pulled over. I would not buy these lights. They suck.

Could do with better connection with stock plugs instead of different connectors. Due to that fact, I haven't been able to install them in my bike just yet

I mistakenly purchased these lights to go on a 1986 Honda 250 street bike. They didn't fit. That's my fault though. Chuck it up to not doing enough research. Due to my affinity to building some of my own gas-powered 'toys' though, I bench-tested them and while they are small in size, they are bright in output. The overall appearance and quality is great too. I'll be holding onto these in anticipation of using them on one of my future builds.

Looks great cant wait to ride winter is way too long

Me llegó sin problema

The lights work great but the rubber doesn't stay on so they just end up dangling off of the bike

Once installed, threading on bolt rips right out of the light, nut on other side can be tightened until the turn signal falls right off!