5Pairs JST-XH 2.54mm 1S 2 Pin 10cm Silicone Wire Cables Balance Plug Lead Socket Male and Female Connector for Bluetooth Headset Drone 3D Printer Automobiles Robots

I've had no issue with these connectors they all worked very well

ok

I used these JST connectors to extend the fan wires on my 3D Printer after I printed a different hot end fan shroud. The cables themselves feel like they are nice silicone wires. The ends are pre-tinned and they were easy to solder to. The connectors hold firm and do not feel like they will disconnect at random. I only needed 3 pair of these, so I'm not sure what I'll do with the rest, but they look like they will be good for various low voltage DC projects.

This is a great JST plug kit for light-duty power requirements. Plugs are nice and snug fitting, but not overly so. Bare lead ends are also pre-tinned. Zero complaints from me.

I bought these 2-pin silicone wire cables to use with Noctua fans and 3D printer, and so far, they've been working perfectly. The cables are well-made, and the connectors fit snugly, ensuring a secure connection.I've taken these guys apart, added zener diodes, switched the polarity, etc. - they've been solid.Since I started using these cables, I haven't faced any issues or interruptions, and both my fans and 3D printer have been running smoothly. The pack comes with five pairs, which is a reasonable amount considering the price. It also comes in a plastic box which is surprisingly great to have for them.The 10cm length was adequate for my setups, and the they didn't add any unnecessary clutter. Overall, these cables have been a good investment.

Easy hook up, worked as needed for my project. Small form allowed access thru smaller holes!