Alchemy Parts Premium Motorbike LED Indicators for Cafe Racer Style Bikes - Black Metal Finish - Motorcycle Turn Signals

Nice, but could be a little brighter especially as they are LED's.

Bought to replace some cheap and very old aftermarket indicators on my 98 bike that were corroding and the lenses cracking.They look good, feel solid, and almost blinded me when I tested one using a battery to power it.Fitting should be easy, as they come with bullet connectors on the wiring, but in my case not so, as the previous set had been bodged on. I will remove the existing tat, and crimp bullet connectors back onto the bike’s wiring.It was a simple job to make up a small stainless bracket to hold the resistors required.I did remove the supplied nuts and replace them with nyloc nuts, so they will not come lose in use,Once they are on I will update with photos.Only down side, someone who packed them stuck sellotape to the outside for some reason, and the adhesive has ‘gone off’ in storage and it proving almost impossible to remove, using 3 different solvents, leaving a stain to the anodised black exterior. I will have to take care fitting, to ensure the marking are on the underside and not visible.Fitting time about 2 hours on a 98 bandit: unscrew & remove old indicators, soldering resistors to wiring harness and mounting resistors on to a custom made stainless steel mounting bracket, trimming wiring on new indicators to length and soldering onto the trimmed down harness plug/wiring from long gone factory indicators, heat-shrink on all soldered joints, general tidying up after to hide wires and cable-tie to prevent chafing. I though it would take longer.UPDATE; 18 months later.The external surface finish has faded/oxidised badly. I do not use harsh chemicals Or a pressure washer to wash the bike, water, and a soft cloth.At some point, probably next winter when the Bike is not in use I will have to remove all 4, rub them down and re-paint them all.One failed in under a year, and was replaced under warranty. As the seller did not ask for the defective item back I disassembled it. The issue was water ingress causing corrosion on the circuit board the LED’s are soldered to.It was easy to see why this had happened. There is no attempt to seal the lamp where the wires go into it. It’s basically open to the elements. Along the same lines the screw-on ring that holds the lens on has no seal. To be blunt. No attempt has been made to prevent water ingress. IPV 0.

I love these indicators and have had a few comments on them from randoms. However they do not like road goo and the black has stained so they do not stand up to close inspection. I would buy again but would lacquer them somehow. (also you will need an adjustable flasher relay for a couple of quid if your bike does not already have a system that supports leds)

Very nice product looks great on bike.

These indicators are fantastic for the price. I've got them on my Bonneville 'Black' and they look the bee's knees. Really good quality, aluminium finish and very bright LEDs but, when not flashing, muted by the smoked finish lens.My only, very minor, con would be that the securing bolts could also do with being black, as they are visible on my bike.

Alittle expensive but good quality and look great

I bought these to go on my quad bike as the ones it came with were not very good at all.These are alot brighter and they are also good quality parts.Ok they are not the cheapest lights but you get what you pay for.Very happy.Alls good.

Replacement for previously fitted leds on my new bikeWorth every penny, couldn’t ask for anything better, look awesome, and much brighter than the originals. Cannot praise these enough.