GEARit Cat6 Outdoor Ethernet Cable (10ft) 23AWG Pure Copper, FTP, LLDPE, Waterproof, Direct Burial, In-Ground, UV Resistant, POE, Network, LAN, Internet, Cat 6, Cat6 Cable - 10 Feet

I bought this because the length i needed to run my new starlink dish was longer than the cable that came in the starlink kit and purchasing a new starlink cord cost almost double what this did. Works fantastic as it should. Could only find a few other reviews talking about starlink but if you read this just know it definately works for starlink. Nice and protected cat6 cable. Worth the money

This is a very high quality cable and works very well for my needs. The cable is very stiff so you can't go around any tight corners. But that is not an issue in my case. I am routing it through large 90 degree electrical tubing. Other than being stiff, it is really nice.

This 150’ cable works flawlessly with the Starlink Gen 3. This allowed us to bury the wire since we have ours on a flagpole Buddy attached to a 12’ 4x4 post with a reach of about 20 feet in the air to avoid some trees. This was a distance from our house where we have a partial sky clearing and was going to use the starlink 147’ cable but its says not to bury it because it will deteriorate in water and dirt. Just note that the cable when connected will pull out if tugged on. But if you carefully attach clips on the flagpole buddy for stress relief it will stay put. Same goes at the router end. The Starlink cable has a rubber seal that helps suction the cable into place. You also have to slide the bubble boots off, (they will slide back if you work them) to make the clearance into the slots.My suggestion do what we did use dielectric grease on the dishy side which will keep out moisture and corrosion which it why the Starlink has a rubber seal. Dielectric grease will do the same thing. Because moisture could enter. Not rain but just morning dew or humidity etc. Rain wont be an issue by design it will be humidity, so dielectric it!The cable is stiff just like coax cable. Looks like that too and about the size of RG6. It will coil just like RG6 so we just worked with it to un coil as we rolled it out then burried it. The wire jacket is a slick plastic and you can tell its made to bury.

Cable arrived in a few days. It was recommended by someone who wrote an article on extending your Starlink cable. I ordered the cable coupler recommended by the same writer. Both worked perfectly. Connected easily and securely. Cost is less than purchasing more Starlink product. Signal strength is great.

My 50' of Starlink Gen3 supplied cable was too short for my anticipated mounting position, needed another 100'. Decided to use this cable along with a waterproof connector to give me 200' total and so far it's working great, no issues or disruptions. I do like the fact that this cable can be buried but for now it's hanging from some posts and my speeds are great. no drops.

I used this cable to get speedy internet to the opposite end of my 126 year old wood house without using a booster. I am fortunate to have a crawl space where I can install the cable on the underside of the joists. It is very heavy duty solid copper with heavy plastic coating. I tried another cable but it quit working after a week.I got the full 1 gig speed through the cable 100' feet from my router. I got a great big hug and kiss from my wife after I used this cable to get her computer functioning again!I do recommend untwisting the cable outside to get rid of the coiling before you install it. I like the idea another user posted about leaving it in the sun for a little while to soften up the plastic sheathing making it more flexible.

High quality cable and great price and fast service

Our church has HDMI ethernet extenders, and they weren't working for the main projectors, but it turned out the cable they had used was 26 AWG, while the extender manuals indicated the need for 23 AWG for the length we were using (200'). This cable was relatively easy to install (although de-winding it from the coil it was in was slightly troublesome, and occasionally the outer sheathing got nicked while we were threading it through some metal girders), and once installed, the extenders worked perfectly. If you need 23 AWG ethernet for your project, this is a good one.

I bought these cables as i have two 100+ foot runs to where i want to place Point to Point Ubiquiti Nanostation AC loco.I have the 150ft Pure copper cable and it works perfectly with the Nanostations and the Nanostations show the SNR of the cable to be well within the acceptable range.Do not get to the Cheaper CCA cables as the POE will likely not work due to the higher resistance of the aluminum cables and the corresponding voltage drop..Some reviews mentioned that the cables are thicker and hard to uncoil, but i put mine on a picnic table in the sun while i planned on where i would run the cables and when i grabbed them to install, they were warm and very easy to uncoil and lay. The cable ends fit just fine in the Nanostations as well without any issues.100% recommend.

I was afraid of cutting this cable and re-crimp on my own. However, it's just way too long for my needs, so off I cut. To my surprise, it's super easy to crimp!

Wanted a good quality cat 6 poe cable to connect an outdoor camera that was 120 ft or so from the NVR unit. The 100 ft of cat 5 cable that came with the camera wouldn't do. Since cat 5 and 6 have the same connections I upgraded. The cat 6 cable ordered was clearly thicker and heavier than the cat 5 which would leave one to believe it is better suited to outdoor use. The one consideration is this cat 6 cable is not as pliable as the cat 5 and as such will be somewhat resistant to remaining connected to the unit if the bend area is too confined unless additional support is placed. Not to say it cannot be bent just that it is much stiffer. Overall very satisfied with the quality and speed of delivery.

I purchased this and returned it. I returned it because it took too long to ship. I needed to get the wires in the ground before the frost. Seller was quick at responding to a return. They accepted and I got a full refund. If the work I do isn't time limited, I would not hesitate to purchase wire from them again in the future. Was a great price, I ended up paying more locally for the wire.

Used to run POE to cameras outside my house. Works as afvertised.