1/4 Wide Heat-Shrink Labels (4-Pack)

ON TIME

I just finished using several of these cartridges for rewiring/upgrading our HOA Clubhouse sound and IT systems. I generated the labels using a Dymo Rhino 4200 labeler(another 5 start review to follow). Having retired I don't have access to my former employer's Brady labelers. The product is excellent and far more economical than Dymo's equivalent product. The Brady equivalent is even more expensive. Lettering is sharp and durable. If you haven't used heat-shrink wire labels before try shrinking them by heating on the opposite side of the lettering. Then tighten in up if needed on the letter side. This will make a tight wrinkle free label every time unless the label was too big to begin with. 1/2" works perfectly on standard CAT5 cable. With some of the thicker shielded CAT6's and above you might want to go to 3/4". Shrink wrap labels 1" and below will not fit over any connector.

Overall, I have not been disappointed with with the Aonomi labels or heat shrink tubes. So, begs the question, when is good, good enough. For me, when value meets your needs without compromise. Highly recommended.

The ability to print on heat shrink is great. They work well for the applications I need them for

I had previously written a review quite critical of this product, before I had actually shrunk any printed labels. Since applying several, I have to report these labels shrink as well as the brand name product, and the quality of the print actually improves with shrinking, so the results are adequate & legible. This is important to me because I have dozens of 22AWG (very small) wires to label so they can be installed properly, and referenced later, as needed. So, I felt to be honest, I must update my review, and now feel that since I have so many labels to make, this was the best choice for me.

Using these w/ Rhino 4200. They fit well, print well and shrink well. Solid product.

EXCELENTE

1. Had amount in roll that was stated, if not a bit more. 2. The first inch or two does not print right but the rest was fine. 3. I ran 2 whole cartridges out during my install not one jam. 4. I don't know how it holds up when pulling cables as I put them on after the pulls. 5. I will buy again when I need more. Just wish they had 4 pack with one of each size up to 3/4.

This product worked perfectly in my Labelwriter 450 Duo, which isn’t commonly known to work with heat shrink tubing.

These are great. Do exactly what you want

Es gibt nichts zu beanstanden. Funktioniert problemlos mit den günstigsten Label-Writern, welche diese Art der Kassetten verwenden...

Always ordering these

Used these as replacement for the originals. Seem to work fine, also outside under UV exposure. Happy with it so far.