Foxpark Solar Wireless Digital Reversing Camera Set (1080P), 3 Minutes DIY Installation, Supports 2 Cameras Wireless with 5 Inch Monitor, IP69K Waterproof for Car, SUV, Van, Motorhome

J’ai acheté ma caméra de recul alimentée par Foxpark Solar en janvier 2023, donc un examen plutôt à long terme. Je l’ai trouvé très facile à installer et il a rendu un très bon service sur mon Toyota Landcruiser. L’image est très claire et lumineuse et même la nuit, avec juste la lumière des feux de recul, elle est facile à voir. Tout allait bien jusqu’à il y a 10 jours, lorsque je n’ai pas pu charger le chargeur de batterie à énergie solaire. J’ai suivi le guide de dépannage dans le manuel mais sans succès. J’ai contacté le service après-vente de Foxpark pour expliquer le problème et dans la journée, une jeune femme appelée Miranda m’a contacté pour me dire qu’ils remplaceraient la batterie / l’appareil photo. L’unité de remplacement est arrivée dans les 4 jours, donc maintenant installée et tout fonctionne à nouveau. Foxpark m’a également accordé une garantie supplémentaire de 18 mois sur l’appareil. Donc une très bonne unité et un très bon service après-vente à la hauteur. Je recommande cet appareil

Wanted a backup camera to make sure that I did not run over anyone or hit anything while backing my vehicle in busy places. Wanted one that was easy to install without a lot of complicated wiring changes to my Dodge Caravan . Found this wireless camera with a built in solar charger that backs up a large built in rechargeable battery that lasts for a very long time in the event of no sun The unit came packaged extremely well, and on opening and examined was very well built and rugged, no cheap plastic stuff here. It comes with the wireless camera transmitter unit with an attached mounting plate , a nice 5 inch receiving screen , a windshield attachment mount , a power cable and a charging cable for the built in battery that backs up the solar panel in the sending camera. The unit also comes with a two sided sticky mount if you want to go that way. The camera has an attached mount that fits onto your front or back license plate using existing bolts. Takes no time at all to attach it to your vehicle. The receiving screen mounts onto the windshield with a adjustable pretty powerful suction cup and plugs into your vehicles power outlet. When you start the engine the unit powers up and activates the camera . The picture is very clear , bright and gives you a pretty wide view of what's behind you. There are buttons on the right hand side of the unit that controls the power on off and the menu of setting options which includes guide line on or off and size of guides, brightness and contrast and time of operation after it turns on . If the picture turns off too soon a touch of the power button on the side turns it back on for another cycle . The units automatically paired with each other when I first powered up which was nice. The receiver can receive from 2 cameras if you buy another one for the front and there are instructions in the instruction booklet on pairing the second camera. I was up and running inside of 30 minutes and so far the unit is performing excellently. I am very happy with this wireless backup camera and as it was a lot less money than other units I researched I think that it is very good value for such a sturdy well built unit. I will edit this review after I have had it for a few months or earlier if things go bad.

On verra à l'usage mais ce produit a l'air de bi n fonctionner et le placement est très facile

I am very happy with the Foxpark camera. It works straight out of the box. The picture is clear and I had no interference issues whatsoever. The camera recharges itself. After 8 months or so the screen died. I reached out to Foxpark and they solved the issue fast by providing a new unit under warrenty. I have to say I was pleasantly suprised: they offer excellent customerservice. Friendly, quick replies and good solutions. I can recommend Foxpark wholeheartedly.

I have a base model 2015 NIssan Altima and it doesn't have a back up camera. I have driven other vehicles that had this and it always helped me. I have depth perception issues and I don't back into parking spaces and sometime I have to adjust my parking even when I am pulling forward. I have a hard time judging whether I am in fully inside my garage and have had my garage door hit the back of my car a couple of times cause I didn't pull in fully. I didn't want to pay thousands of dollars to have my console upgraded and a backup camera installed and so I went searching for a wireless option. The only problem is that even though most of them are wireless they still require you to wire into your reverse light in order to work and this was out of my skill level. I wanted something I could install easily and didn't require any wires. I stumbled upon the solar options and after many reading many reviews, I finally decided on this option. The shipping was fast and when I got home from work on the day that I received it, I started to install the unit. Now, for people who know exactly what they are doing, this is probably a 10 minute install but I went in with several assumptions and that delayed the install. First, I thought I was going to be able to install the camera onto the license plate at the top; however, my license plate is located in a recessed area of the truck and is already situated close to the top where the trunk release button and so if I placed the camera there, I would never be able to open my trunk. (I attached a photo that where I circled the truck release so you can see how close it is to the top of the license plate). Second, my car didn't come with holes for the bottom of the license plate so I was unable to have it secured to the bottom part of my license plate as well. I was thinking I would have to send this back but then I remembered the sticking strip that was sent with the camera. This was actually a better option for me since it allowed me to affix the camera to the right of center which actually put the camera part itself almost dead center of the car. I attached a couple of photos to show the camera on the bottom and how the actual camera part is almost center. I removed the license plate completely, cleaned the entire area and dried it completely. Determined the placement of the sticker and then applied it. I then placed the camera still attached to the bracket onto the sticker and held it in place for a few minutes. I then cleaned off the license plate itself and replaced it. I then moved onto figuring out the placement for the monitor. I have a non textured area directly above my console that I initially tried to place the monitor; however, that area is slanted and the monitor wouldn't stick. It kept falling off! The instructions state to place it on a non-textured flat surface. The rest of my dashboard is textured but I have more options of a flat surface. Placing it on the windshield is not an option for me because then I wouldn't be able to use my sunshades in the summer time. So I found a place that was in line with the driver's view and it was a little farther back where it was flat and although it was a textured surface - it stuck! And I mean it stuck solid! After I placed it on the flat area, I had decided I was going to adjust the position just a little but it was so solid that I decided to leave it alone. After watching several YouTube videos, I was able to figure out how to pull the trim off my dashboard which allowed me to hide the extra cable behind my radio and a small hole was just above the area where my cigarette lighter. You can see from the photos I attached that only a small portion of the cable from the monitor is visible where the monitor is at and down where the product plugs into the cigarette lighter. So I put several objects behind my car at different distances and with the help of my son, it allowed me to adjust the camera to the proper level. I have been driving for over a week with this product installed and I just LOVE it!. I no longer have anxiety pulling out of a parking spot and hoping there is enough distance between me and the cars parked on the other side. I backed into my garage for the first time and it was a breeze. When I pull forward into my garage, I no longer have to get out of the car to see if I have pulled in enough to clear the door, I just hit the monitor and line up the grid line to the line on the cement that separates the garage from the driveway and viola, I am in with no problems. The grid lines are slightly off on one side because the camera isn't dead center. (I wish now I would have installed it more center than I did but the sticky stuff they sent works really well and I'm not getting it off to readjust the camera). After driving with this product and the installation issues that I ran into, I have a couple of suggestions for those of you who are like me. Before the product arrives, visually look at where your license is at and determine how much space you have between the top of your plate and the trunk release and also if you have holes in the bottom to mount there if needed. This product is bulky. Also look for flat area on your dash board to mount, flat is more important than smooth texture. IF I had done this before hand, I would have saved a ton of time when I went to install it. My next suggestion is based on my need for accuracy of the grid lines. I would highly suggest to avoid mounting the camera onto the license plate with the screws because that puts the camera itself on the side and thus the grid lines will not be accurate. If you are after a cleaner look or don't rely on the grid lines to park/maneuver then this suggestion will not apply to you; however, if you don't mind the look of the product being off center or need accuracy for the grids, then use the sticking tape that comes with the product and mount it where the camera will be dead center. As I said before, I wish I had mounted it a little farther over than I what I did so that the camera would have been center but that ship has sailed cause its stuck so well that I can't move it! Also, my cigarette lighter area is down in a recessed area of the console and I found that I had to lean forward quite a bit in order to hit the button to activate the monitor. So I went ahead and purchased a splitter that brought the power button up out of the recessed area. It not only made it easier for me to reach the power button of the monitor but it also gave me another cigarette lighter port for other devices that require that. You can actually see that splitter in the photo where I am showing the wire under the console. I would suggest getting a splitter if your cigarette lighter area is a little out of your reach. I have placed the URL here for anyone who wants to know. (https://www.amazon.com/dp/B07FDQLL7K?psc=1&ref=ppx_yo2ov_dt_b_product_details). I am so happy with this purchase and if I ever get another vehicle that doesn't have a backup camera, this is going to be my first purchase for that vehicle! If you are after something easy to install, easy to use, and doesn't cost you your first born to get - then get this camera! Highly recommend!