VEVOR Ratchet Pipe Threader Kit with 6 Dies, 1/4" NPT to 1-1/4" NPT Ratcheting Pipe Threading Tool, Portable Pipe Threader Set with Storage Case for Plumbing Installation and Repair

I had no experience threading pipe but found success with this product. The instructions are clear and the die cut well enough (I only used the 3/4”). Ended up threading 3 pipe ends and all of them came out perfectly. Added lots of oil as I went. No doubt I could do a few more before the cutter starts wearing too much. I’m completely satisifed with how well this worked.

Good pipe threader for the price. Was using it to install some RMC conduit and it did a great job. My only complaint is that the die pushes out of the handle somewhat too easily, but it's not a showstopper. The teeth did not seem to wear at all after a dozen uses, so the material is of decent quality. It is very, very important to use LOTS of oil. Put some in an oil can and squirt it every half a turn or so. Otherwise, the cutting action will not be smooth and you will get galling, poor results, and the tool will become dull quickly. This is true of an expensive threader, too.

Worked great. Made nice threads. Make sure the die is set level on pipe. Definelyy is a workout and you'll need the leverage.

For the price it’s not bad for small projects. Make sure to oil while cutting and reverse often to break loose the cuttings.

Awesome tools for a project like plumbing

I needed to run a new gas line for a garage heater, which involved threading multiple sections of 1/2" and 3/4" black iron pipe, and decided to put this kit to the test. Right out of the case, the tool feels substantial. The dies snapped into the ratcheting head with a positive lock, and the reversing mechanism is simple and solid. I clamped a 3-foot section of pipe in my vise and got to work. Using a generous amount of dark cutting oil, the ratcheting action was smooth and provided excellent leverage, allowing me to apply steady, even pressure. It bit into the pipe immediately and started cutting clean, continuous spirals of metal. I backed it off a half-turn after every full rotation to clear the chips, as is standard practice. The process was demanding, as manual threading should be, but the tool handled the torque without any flexing or chatter. The most critical finding was the quality of the threads themselves. The high-speed steel dies are impressively sharp and well-machined. They produced clean, perfectly tapered NPT threads that were free of burrs or tears. I test-fit a black iron fitting onto each one, and they threaded on smoothly and tightened up perfectly after 3-4 turns, exactly what you want for a secure, leak-proof seal.

It work the frist 2or 3 now the 3(4 die isn't so good

It made the threads I needed. Good value for occasional use.

Works good, advertised as NPT… it’s definitely not npt

It does the job for cheap It’s not that expensive a rigid set and the dies sit in the handle differently Had to file the 1/2” die inner diameter a bit to fit standard black pipe had paint build up in die Does the job Made 4 pipe sections so far Do not forget to use oil while cutting threads Too Much is just enough

mon mari en est très content, il avait de vieux tuyaux et il a pu faire des parties à visser facilement avec cet outil, super et très raissonnable en prix

Cheap and get the job done

Easy to use