EVIL ENERGY 2.5'' Exhaust Clamp,Lap Joint Band Clamp Stainless Steel for Pipes,Mufflers,Catalytic Converters (1, 2.5 inch)

Fit right up - withstood my impact to tighten it. Put some loctite on the bolts - there aren’t any locking washers.

Good quality, has been installed a week and no issues. I'd buy another one if needed. Just measure your pipes get the right one.

This is an easy to use clamp. Bolts on and provides a secure fit.

2.5” was too small and 2.75 was too big. Had to wrap the pipe and add some aluminum to get a snug fit. Nice product that seems high quality and solid bolt on design.

I like how these clamps cover the joint. Makes a good seal.

I used this product to connect the exhaust pipe to the muffler. It fits perfectly with a little room for an expanded piece. After tightening the clamp, it will slightly deform the exhaust pipe creating a seal from pipe to pipe. I recommend using a muffler/exhaust pipe sealer before installing the clamp just to be safe. Bottom line it works—three weeks so far and no issues.

I'm giving it three stars only because the bolts are too short. They just need to be about a quarter of an inch longer just to grab enough threads to be tightened correctly without stripping the threads out of the nut. Also It'd be better to describe the part with only outer diameters of the pipes being joined "OD"on both ends of the product. Otherwise you're just confusing everybody.Anyways I got mine to work but I had to basically drill out the bolt holes on little aluminum spacer so that the spacer would go lower thus increasing the diameter of the steel band which allowed me to put the nut on to the bolt.

It works as advertised.

Unfortunately I didn’t use this product did not work with my application

Had to connect two exhaust pipes. One is 1 inch diameter and the other is 1.25. I loosened the clamp but couldn’t just slide and attach it cause the other pipe was too big somehow. So i disassembled the clamp and assembled it back over the pipes and it worked. Good stainless materials, not flimsy at all. We have winters here so hopefully it will not rust so much and last a couple of years.

I replaced my car's catalytic converted, I had to cut the 2" pipe just before the resonator. Installed the new cat, and than this is where this clamp comes along. Perfect fit. Remember you have to wrap it around the pipe, it is no to be slide in. Looks very professional, no leaks, it does not deform the pipes like the regular exhaust clamps, so if you need to replace an exhaust component later on, no problem. highly recommended

Needed a clamp for my 2016 Ram 1500. The OEM was on back order everywhere so decided to give this 3” a go. Worked great! No exhaust rattle or leak anymore.

I am impressed with the quality of this clamp. It is working very well on my truck. I put a couple layers of aluminum tape under it and there are no leaks. I was able to make it very tight.