423360-7 Rubber Splinter Guide

I bought this for my Festool 1400/2 guide rail, I was initially skeptical about not choosing the genuine Festool version. However, at a third of the price, it was worth a try, and there’s enough to cover two 1400mm guide rails too. After removing the old splinter guard, I cleaned the rail with a Big Wipe, but the residue prevented proper adhesion. I then used rubbing alcohol on a microfiber cloth to remove the residue, and it then adhered perfectly. When trimming it down with the track saw, I noticed a difference from the Festool version. Instead of cutting off a strip, this one turned into crumbs which made a rite mess despite being attached to the extractor. First use was on 6mm MDF, it was easier to line up and delivered results that, in my opinion, were better than the genuine Festool version. It’s also noticeably sturdier.

Got this for my dewalt guide rail. Was going to pay £30 for dewalt own until I saw this. Fits perfectly, adhesive seems good. Trimmed down beautifully. And the 3rd of the price. Some have said it comes up short in length. Mine was about 3050mm Will be buying another one.

Genuine makita easy install, just clean the track with alcohol and good to go.!!

Bought to replace splinter guard on 2 x 1.5m Makita guide rail / tracks. Tracks were connected together and new splinter guard applied (old adhesive removed with stanley blade) . Quick check before fitting and length seemed to be OK, however upon fitting and despite starting dead size (no overlap) found it was approximately 25mm too short. Laid in place to avoid stretching - perhaps stretching is required? Typically with rails this long 2 passes are needed where the track is split and joined together again to pick up the untrimmed start/end of each track. This means that the gap is in the centre adjacent to the track joint.

Excellent item

Great consumable for your track. Unlike some others , this one has some flexibility. Swapped out OEM guards on all my rails for this one. Good adhesion - enough to allow re-positioning/trimming if you just ding a small part.

There is nothing wrong with the adhesion of this product! As I'm sure a few of of us have, I caused a significant amount of damage to the guard strip that came with the saw, and baring in mind that's the reference point for a cut, it made cutting square a guessing game. Finally located a replacement that I felt was a fair price for what it was, and noted some reviews complained about the strip not adhering properly. To those I would ask, did you properly clean the track before affixing the new one? And I doubt some did! After removing the old I used a microfibre and mentholated spirits to thoroughly clean any old residual and used a second microfiber to ensure it was completely dry. Line up and apply the strip and then using a thin strip of ply (or what ever wood you have) place over the strip and clamp up and down the track and leave for half an hour. The strip is permanently attached to my saw. There are no gaps for the dust to get underneath (even the joy of MDF dust) and once I did a 'dry' cut with the saw, I was left with a perfectly trimmed guard edge and back to square cuts.

Used on my Dewalt plunge saw track. Perfect fit and works brilliantly.

Très bien, remplace celui du guide Bosch

Does what it's supposed to do

Reçu rapidement il s'adapte parfaitement à mon rail (Métabo) et même le Parkside !

Gutes Material; klebt gut und ließ sich problemlos perfekt einsägen. Passt perfekt zur alten Festool- Schiene

Perfetta per guida originale sega ad immersione Makita