5Pcs Bedroom Black Button Plastic ON/Off in Line Cord Switch AC 250V 6A (Black)

Plastic construction could be better, but functions well. Have used one so far, works as described.

Used these for a little electronics project. worked well.

Great product, good quality, like to buy hundreds of pieces at a reduced price.

This product is an example of good parts bad assembly. The switch, Contacts and Housing each by themselves are decent units, but the whole unit is flawed and unsafe. The Internal contacts are loose to start with and the retaining screws have weak thread which easily strip the plastic. The internal metal contacts are only touching the switch contacts (and loosely so due to loose screws) causing them to rattle around. And finally there are no screws included to actually attach your wiring to the metal contacts inside the switch housing.

Screws are anchored in plastic which could be stripped with too much force. This would be a better switch if the screws holding the two halves together were longer and had a nut on the other end, instead of anchoring them in the plastic casing.

Good quality for the price way to use.

They are great

Ships as a bag of parts: 10 case halves, 10 case assembly screws, 10 terminal screws, 10 screws for securing the contacts, 10 contacts, and 5 switches. A little concerned with the connection between the switch and the contacts due to pressure only, but measurement with a multimeter shows the total resistance between the terminal screws as 1-2 ohms. If actually intending to use this for a 6A load you probably want to buy something else but for for the quarter amp less a modern LED lamp will draw it's adequate.

No instructions how to assemble

All in parts come in,had install myself

Comes disassembled in a total of 55 parts.This is not told in their description on Amazon.Do not buy.

Switch contacts are not attached to wire contact plates securely. Can cause arcing. Soldering or bending/pressing is required.Some people seem to be missing wire holder screws, mine had it. Did not see case holding screws at first, so cut some M3 screws that worked well.