ANZO USA311100 Chevrolet/GMC Yukon Denali G2 Red/Clear LED Tail Light Assembly - (Sold in Pairs)

I have 04 Tahoe with barn doors. went on just fine. Many other LED tail light didn't fit. Gave the truck a great look. Will say install little more than most have to get under the truck and unplug the factory wire harness and the provided harness in.

I have had these installed on my 02 GMC Yukon XL with the cargo (barn) doors for 6 months and absolutely love them. Very bright, brighter then stock fixtures and bulbs.Yes, they come with two sets of plugs on them, just cut the one off that you don't need for your installation as close to the harness as possible and wrap with a good electrical tape like 3M Super 33. For my installation I also removed the loading resistors from the fixtures and installed an LED compatible flasher unit. If you remove the load resistors as I did, you will need to install a 2.2k Ohm 1/4 Watt resistor across the brake light wires on one of the fixtures to keep the cruise control operational (Blue and Solid Green wires.)For those who wished the backup lights were LED as well, I installed a set of 3156-W15-TL white LED bulbs. These made for extremely bright and actually useful backup lights, an awesome combination with the Anzo LED tail lights.

First off they're not total LED tails. The reverse light is a BULB. I didn't want BULB lights. The far bottom of the assembly is a driveway reflector incased in plastic.The install actually makes you replace the whole wiring harness down to the body of the truck. In my Tahoe's case I had to crawl under the truck and detach the wiring harness from the truck. BE careful as you're prying off the plastic as it tends to snap.This also makes you believe that it's American made.. As they call their company Anzo USA. It's not. Made in Taiwan.The directions are a single sheet of paper which is in english and possibly chinese?? Furthermore, the instructions tell you to cut off the end of the wires which do not fit to your vehicle. (It comes with two different connectors. You're supposed to cut the unused one off.) I don't think i'll be doing this as these will most likely be going BACK.

I installed these on a 2003 Suburban with barn doors. They fit perfect with absolutely no modifications required. The only tool i used to install was a Philips head screw driver. Took about 15-20 minutes. It comes all wired up with resistors, so no hyper flashing. Also comes with instructions. Everything worked! They look good. Happy so far. Will update if units fail in any way.

I bought these for my 2003 Suburban, and I love them. I can't say anything about the installation, as I was involved in a fender bender, and these were bought through the insurance money and installed by the body shop. All I know is they didn't complain.Pro's: Bright and they brought a little glam to my stock truck. A friend of a friend said "how did you buy the new truck?" in reference to a photo i posted, i laughed. Also, Amazon is very fair in their pricing versus a aftermarket shop.Con's... Haven't found any.

These are replacements for my last set. I got over 5 years of life out of the first set, so I expect the same for these. They fit almost like OEM. The mounting holes were a little off, but not enough to cause any problems. Quite bright in daylight as well. Don't spend twice the price on other units, these will serve you well and look very much like OEM until the LEDs come one.

great price showed up fast good fit but right light took minor modification to fit the barn door style tahoe.

Just 4000 miles later, passenger side brake lights fail to ignite. Researching cause/solutions with no success. Waiting for response from customer support. Appreciate informed input.