GDSTIME 80mm x 20mm 8020 12V Dc Brushless Cooling Fan Sleeve Bearing 2Pin

Used this fan to fix my mini fridge. Worked great. Only had to swap the positive and negative leads in the connector. Almost silent.

On the plus side, the fan works fine.FYI, if you are using the fan to replace a bad fan on a Rosewill external hard drive case, the connector is not compatible. You have to cut the connector off of the new fan wires and splice/solder the connector wires from the old fan so that it will plug into the board. It is not hard or long to do. You have to remove all 4 side panels and remove the HDD to change the fan. The fan is held in by 4 screws. It is pretty easy.

Totally silent. It doesn't appear to move a ton of air. But, it moves it where it is needed as a replacement for the stock fan on an EVGA GTX 650 SC.The fan motor is small and the full heat sink of the video card is now effectively cooled (a previously installed fan moved more air but, was loud, too tall, and the motor diameter too large to cool the center).The connector is a perfect fit.Note: This fan is effective for me in a free air install. Closed case temps WILL effect your results.

UPDATED:I was pleasantly surprised when the seller reached out to me after reading my review. I DID NOT contact the seller or initiate a return as the original review below shows, it was my fault for breaking the fan. Seller sent me a replacement as well as a fan grill even after I told them I wasn't expecting them to.A rare gem in customer service these days. The fan itself still has the same flaws but the customer service makes this a 5/5 experience------------------I know, I know, you aren't supposed to stick your fingers in spinning fans. I had plugged the fan in just to make sure it worked before I installed it in the final destination. It clipped my thumb and one of the fins shattered!Before the fin broke these fans were quite quiet. Now they make some noise because of the uneven cadence due to the missing fin.The fans work as advertised but I have never broken a fan before in the dozens that I have handled, by simply brushing the fin.

This replaced a factory hard drive fan, the old one made noise and then started grinding. This one moves alot of air and you can't tell if it's even on. I love it. Its a 2 pack so just in case, I'm ready to replace.

Works well but be advised wires were wrong, had to swap wire sides in plug then worked fine

There is only things to like for this fan. It's quiet, and helps to cool the poor design of my Motorola radio. I use this to keep my TX (transmission) Motorola repeater side cool. For some strange reason Motorola decided to put the heatsink on the bottom, when it's known that heat rises. I'm sure there are many more uses for this cooling fan, You just need to find a way to utilize it. Would recommend.

Buen producto