Tenryu SL-18552 7-1/4" Carbide Tipped Saw Blade ( 52 Tooth ATAF Grind - 5/8"Ko Arbor - 0.063 Kerf)

I needed to make several cuts in a bunch of red oak, and I didn’t need any rough ends or splintering. This blade did the job, cut quickly and smoothly, leaving a razor edge in the wood and not stressing my saw.

See attached photographs of inserts as received from manufacturer, delivery fully intact with no damages, even a plastic/vinyl strip around the diameter for protection post manufacturing. I had higher hopes based on others reviews...

I put this on a Milwaukee 7-1/4” cordless saw and it rocks ! I was using a CMT and I can say that the cuts are a little cleaner with this blade (tear out on thin side of work pieces) and the battery life on the saw is better by half a day or so. I own several of these blades for my table saw and 12” saws and they work great. Quality is there for sure with this !

This thing is amazing.Supewr sharp and super smooth cut.It does deflect some when doing compound miters, so i have another blade for doing crown, but this one is hard to beat other then that.

Small trim cutting 1/4 toe kick and found it missing a tooth…

I used this in my circular saw to cut expensive veneered plywood. Very little tear out even when cross cutting. This blade if slightly thinner than other thin kerf blades. Recommended

Used it to cut 3/4 inch oak plywood. Had very minimal tear out. Cut smooth and had no issues at all.

cuts threw pine like its not there with my small miter saw ! 10 starsjust cut slowly when cutting thick hardwood, thin blade can tend to wobble if cutting to fastsaws craftsman & milwaukee 7 1/4