Kydex Holster for Sig P365XL & P365 Trigger Guard Pistol 365 XL Lanyard Rip-Away Pocket IWB Carbon Fiber

Use it with a clipdraw. Fits snug doesn't feel like it will fall off like my mic holster. Knoted the lanyard in a big ball easy to grab and pull off. Wish they made one for the shield.Chance Teague

Ok out of the box but fitment was way to tight. Pulling it free was rather difficult.To loosen it up I did the following:Bring a pot of water to a boil and put an oven mitt on one hand.Hold the MIC by the attached string and lower it into the water.Leave it there for 5 seconds.Remove it from the water and gently grasp with in the mitt.Shake the water off it and insert your Sig while holding edges snug against the frame.Allow it to cool for a couple of minutes before removing and testing.If still too tight then repeat until you like the fit, leaving it in the water a couple of seconds longer each time.This takes a little time, but well worth it. Once done it should slide on/off, with a soft 'click' feeling when in place.

Seemed to be good quality but it was much too tight fitting. Even tried to heat it up some and it didn't work, had to return it after it put a gouge in my trigger guard.

Terrible job. I had to heat and form for a flush fit. I’ve had several of these from other makers that were great. I went with this one because of the prime shipping